Eşyalarını Tamir Et Topluluk Mağaza

Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement

Giriş

This repair is very easy; all you need is a T5 Torx Screwdriver, and a new Digitizer Glass & Frame Assebly - it's better to order it with the Front Frame as well, as it makes repairing a lot simpler, and will give your phone a new look and feel.

Neye ihtiyacın var

  1. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement, Touchscreen Glass / Digitizer Assembly: adım 1, 1 resimden 1.

    • The first thing you'll need is a Nokia Lumia 610 with a broken front glass

    Düzenle

  2. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: adım 2, 2 resimden 1. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: adım 2, 2 resimden 2.

    • Slide the back cover off, and remove the battery

    Düzenle

  3. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: adım 3, 2 resimden 1. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: adım 3, 2 resimden 2.

    • There are 8 Torx 5 screws you have to remove, 4 on each side

    Düzenle

  4. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: adım 4, 3 resimden 1. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: adım 4, 3 resimden 2. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: adım 4, 3 resimden 3.

    • After removing all 8 screws, proceed to prying off the back cover

    • This is done very easily, by prying it from the 3 grooves depicted

    • This step might also be done using your nails, as the clips are not strong at all

    Düzenle

  5. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: adım 5, 1 resimden 1.

    • Watch out - the buttons easily fall out; just make sure you don't loose any, a'aight ?!

    Düzenle

  7. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: adım 6, 2 resimden 1. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: adım 6, 2 resimden 2.

    • Lift the back cover up, and pull it back - most likely, the 2 sided tape sealing the camera module will be the last thing to break loose

    • Make sure you stick it back to the rear case assembly after this step

    Düzenle

  8. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: adım 7, 3 resimden 1. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: adım 7, 3 resimden 2. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: adım 7, 3 resimden 3.

    • Disconnect the 2 ribbon cables connecting the LCD & Digitizer to the motherboard

    Düzenle

  9. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: adım 8, 1 resimden 1.

    • Now to separate the Motherboard from the front assembly !

    • Gently pry on the 2 hooks depicted in the picture to release the motherboard

    • Again - using your nails should be just fine !

    Düzenle

  10. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: adım 9, 2 resimden 1. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: adım 9, 2 resimden 2.

    • Lift the motherboard up from the back, and pull it backwards

    • Apply the same motion as with the back casing

    • You should now have separated the motherboard from the LCD/Digitizer Assembly

    Düzenle

  11. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: adım 10, 2 resimden 1. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: adım 10, 2 resimden 2.

    • To detach the LCD, gently lift it from the sides - be careful, and don't pull too hard on the ribbon cable !

    • It's secured in with pretty weak double-sided tape, so this step shouldn't be a problem

    Düzenle

  12. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: adım 11, 2 resimden 1. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: adım 11, 2 resimden 2.

    • Remove the ear-piece speaker from the Digitizer Assembly

    • It's held in by - again - pretty weak double-sided tape

    • 2nd picture gives you a look of the front of the speaker unit - it's pretty hard to damage the membrane - though, you can never be too careful !

    Düzenle

  13. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: adım 12, 2 resimden 1. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: adım 12, 2 resimden 2.

    • Something very easy to forget - remove the tiny rubber gasket for the microphone, and place it in the new front panel

    Düzenle

  14. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: adım 13, 1 resimden 1.

    • To put everything back together, just follow the same steps backward, and you should have yourself a good-as-new Nokia Lumia 610

    • The last step in this guide - is trying not to break it again :)

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

7 farklı kişi bu kılavuzu tamamladı.

Yazar

2 tane daha katılımcı ile

Darie H

Üyelik tarihi: 11/20/12

4.580 İtibar

5 adet Kılavuz yazıldı

Rozetler: 16

+13 tane daha rozet

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 6

Son 7 gün: 12

Son 30 gün: 18

Her zaman: 5,723