Eşyalarını Tamir Et Topluluk Mağaza

Nortel Networks i2004 IP Speaker Replacement

Giriş

If you can't hear the other line, then your speaker is broken. Use this guide in order to replace the damaged speakerphone speaker.

Neye ihtiyacın var

  1. Nortel Networks i2004 IP Speaker Replacement, Back Cover: adım 1, 3 resimden 1. Nortel Networks i2004 IP Speaker Replacement, Back Cover: adım 1, 3 resimden 2. Nortel Networks i2004 IP Speaker Replacement, Back Cover: adım 1, 3 resimden 3.

    • Flip the phone over to view the back.

    • Remove the power and phone cords.

    Düzenle

  2. Nortel Networks i2004 IP Speaker Replacement: adım 2, 1 resimden 1.

    • Remove the seven 8mm Phillips #2 screws.

    Düzenle

  3. Nortel Networks i2004 IP Speaker Replacement: adım 3, 2 resimden 1. Nortel Networks i2004 IP Speaker Replacement: adım 3, 2 resimden 2.

    • Lift up the back cover slowly because there are still wires attached to the circuit board.

    • Lifting the back cover should not require a lot of force; simply lift with your fingertips.

    Düzenle

  5. Nortel Networks i2004 IP Speaker Replacement: adım 4, 1 resimden 1.

    • Disconnect the rubber piece by pulling it out of the slot, freeing the back cover completely.

    Düzenle

  6. Nortel Networks i2004 IP Speaker Replacement: adım 5, 2 resimden 1. Nortel Networks i2004 IP Speaker Replacement: adım 5, 2 resimden 2.

    • Remove the six 8mm Phillips #2 screws.

    • Pull the speaker phone cover straight up.

    Düzenle

  7. Nortel Networks i2004 IP Speaker Replacement, Speaker: adım 6, 1 resimden 1.

    • Lift the speaker straight up.

    • The speaker may need to be slightly wiggled in order to loosen and remove.

    Düzenle

  8. Nortel Networks i2004 IP Speaker Replacement: adım 7, 1 resimden 1.

    • Cut the red and white wires as close to the speaker as possible.

    • Wire cutters are preferred, but normal scissors are fine too.

    Düzenle

  9. Nortel Networks i2004 IP Speaker Replacement: adım 8, 2 resimden 1. Nortel Networks i2004 IP Speaker Replacement: adım 8, 2 resimden 2.

    • Solder wires to new speaker.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

Yazar

5 tane daha katılımcı ile

Elizabeth

Üyelik tarihi: 01/21/12

160 İtibar

3 adet Kılavuz yazıldı

Rozetler: 7

+4 tane daha rozet

Ekip

Cal Poly, Team 10-35, Amido Winter 2012 Cal Poly, Team 10-35, Amido Winter 2012 üyesi

CPSU-AMIDO-W12S10G35

4 Üyeler

10 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 1

Her zaman: 1,123