Giriş

Use this guide to remove the frame from the screen on your OLPC XO 4.0 Touch.

Parçalar

Hiçbir parçaya gerek yok.

Turn the laptop upside-down, with the handle facing away from you.
  • Turn the laptop upside-down, with the handle facing away from you.

Yorum Ekle

Pull the lock tabs towards the green outer edges of the laptop.
  • Pull the lock tabs towards the green outer edges of the laptop.

  • Hold the left lock tab in the unlock position until the battery is completely removed in the next step.

Yorum Ekle

  • Lift up on the middle of the battery to remove it from the device.

Yorum Ekle

  • Remove the two 4mm Phillips #1 screws underneath the screen on the right-hand side.

  • Rotate the screen 180° and remove the other two screws.

  • You will have to put your screwdriver through the handle in order to reach the middle screw for both sides.

Yorum Ekle

  • Remove the green side panel by pressing down on the small green button on the top and sliding the panel up.

  • Repeat the step above for the panel on the other side.

Yorum Ekle

  • Be careful not to pull the bottom too far out because a ribbon cable is under the frame and can easily break.

  • Gently lift up the lower part of the frame and pull it down to free the screen frame.

Yorum Ekle

  • Lift the black connector and pull the ribbon cable out by the purple tab, freeing the frame.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Ji Kim

Üyelik tarihi: 25-01-2013

18 İtibar

3 adet Kılavuz yazıldı

Takım

Cal Poly, Team 3-29, Amido Winter 2013 Cal Poly, Team 3-29, Amido Winter 2013 üyesi

CPSU-AMIDO-W13S3G29

4 Üyeler

10 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 0

Her zaman: 109