Giriş

This guide will take you through all the steps to sucessfully install a new logic board to your Olympus D590 camera.

Parçalar

Hiçbir parçaya gerek yok.

Flip camera so you are looking at the bottom.
  • Flip camera so you are looking at the bottom.

  • Unscrew all 5 base plate screws.

Yorum Ekle

Lift open retainer clip by sliding the clip to the left and letting the clip pop up.
  • Lift open retainer clip by sliding the clip to the left and letting the clip pop up.

Yorum Ekle

Unscrew the single screw located next to the battery slot.
  • Unscrew the single screw located next to the battery slot.

Yorum Ekle

Turn the camera so that the USB, AV and DC in/out rubber plate it facing you.
  • Turn the camera so that the USB, AV and DC in/out rubber plate it facing you.

  • Lift the rubber plate exposing the ports beneath.

Yorum Ekle

Unscrew the 2 screws next to the USB and AC ports.
  • Unscrew the 2 screws next to the USB and AC ports.

Yorum Ekle

Use a flathead screwdriver or another flat opening tool to pry the faceplate from the whole device.
  • Use a flathead screwdriver or another flat opening tool to pry the faceplate from the whole device.

Yorum Ekle

Pull off the faceplate to reveal the inside of the camera.
  • Pull off the faceplate to reveal the inside of the camera.

  • Be careful of the connector that goes from the faceplate to the motherboard . Disconnecting this line will cause the camera not not power on through the on/off switch anymore.

Yorum Ekle

Unscrew all 4 circled screws.
  • Unscrew all 4 circled screws.

Yorum Ekle

The logic board should now be loose and easily liftable.
  • The logic board should now be loose and easily liftable.

  • DO NOT lift the board out completely the wiring that is still connected must be disconnected before proceeding.

Yorum Ekle

Disconnect the 3 wiring strips from the device by gently pulling with tweasers from the base of the strip. Do not use sharp tweasers because the wiring might tear. Make sure to use small force so the wiring is not damaged.  It may help to gently wiggle the tape.
  • Disconnect the 3 wiring strips from the device by gently pulling with tweasers from the base of the strip.

  • Do not use sharp tweasers because the wiring might tear.

  • Make sure to use small force so the wiring is not damaged. It may help to gently wiggle the tape.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

2 başka kişi bu kılavuzu tamamladı.

Sara

Üyelik tarihi: 15-04-2010

84 İtibar

2 adet Kılavuz yazıldı

Takım

Cal Poly, Team 28-23, Regan Spring 2010 Cal Poly, Team 28-23, Regan Spring 2010 üyesi

CPSU-REGAN-S10S28G23

4 Üyeler

7 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 0

Tüm Zamanlar: 1,606