Zorluk
Orta
Adımlar
10
Gerekli Süre
5 - 10 dakika
- Case % 1 adım
- LCD Display % 1 adım
Öne Çıkan Kılavuzlar
Bu kılavuz, iFixit kadrosu tarafından acayip havalı bulundu.
Giriş
Use this guide to replace the LCD.
Parçalar
Hiçbir parçaya gerek yok.
-
Unscrew the bottom and right side panel screws using a #00 screwdriver. (5 screws)
-
Remove the right side panel by pulling off the large silver piece.
There is no reference to removing screws from the right side panel, where it is necessary to remove 2 screws to do so.
-
Unscrew the remaining side and front panel screws using a #00 screwdriver. (3 screws)
-
Using your thumb and forefinger, pull off the silver name plate and silver "T-shape" piece. (2 pieces)
-
Remove the black front panel by sliding it towards the lens and then pulling it up off the camera.
-
Remove 3 screws from the front of the camera using a #00 screwdriver.
-
Lift the two tabs to separate the case using a spudger. (one tab on top and one tab on the right side)
Wrong point of focus for the second picture. What should be in focus is very blurry.
-
Using a plastic spudger, lift up the black clips.
-
Still using the plastic spudger, detach the gold connector strip and white connector strip.
-
Using both hands, pull the camera apart into two pieces.
There were multiple gold strips, so the one that needs to be pulled should be highlited in the picture.
in step seven pull up the black bar of the ZIF connectors before pulling out the white or gold ribbons
-
Peel up the blue and black tape. This can be done with a spudger.
-
Unscrew the screws. (6 screws)( photo shows 7 screws -editorial comment)
-
Push out the LCD screen by pushing on the screen side.
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
İptal et: Bu kılavuzu tamamlamadım.
2 başka kişi bu kılavuzu tamamladı.
Takım
Cal Poly, Team 13-4, Forte Winter 2011 Cal Poly, Team 13-4, Forte Winter 2011 üyesi
CPSU-FORTE-W11S13G4
6 Üyeler
6 adet Kılavuz yazıldı
Put a notice on here that the screws are very small and are easy to misplace while disassembling device. Also, while disassembling the device there was only one screw present, where the guide suggested there were three.
Curtis Reedy - Yanıt
Before beginning, put a note that the camera should be turned off before proceeding.
Curtis Reedy - Yanıt
Add a note at the beginning of the guide that there are a large number of small screws that should be separated as the steps are completed.
Curtis Reedy - Yanıt
There's a capacitor .....watch out for it in every step.
BILL BOYD - Yanıt