Ana içeriğe geç

Bu kılavuzda güncel değişiklikler var. En son onaylanmamış sürüme geçin.

Optical Drive Enclosure Faceplate

Salt Önkoşul
Bu kılavuz yalnızca diğer kılavuzlar için bir ön koşul olarak kullanılmak üzere tasarlanmıştır. Tek başına eksiktir.

Neye ihtiyacın var

  1. Optical Drive Enclosure Faceplate, Optical Drive Enclosure Faceplate: adım 1, 1 resimden 1.
    • Remove the three 3.0 mm Phillips screws from the optical bay enclosure.

  2. Optical Drive Enclosure Faceplate: adım 2, 3 resimden 1. Optical Drive Enclosure Faceplate: adım 2, 3 resimden 2. Optical Drive Enclosure Faceplate: adım 2, 3 resimden 3.
    • Starting from the left edge, gently pull open the optical bay enclosure.

    • Continue to pull open the two halves of the enclosure until they separate.

  3. Optical Drive Enclosure Faceplate: adım 3, 1 resimden 1.
    • Remove the two 3.0 mm Phillips screws securing the faceplate to the optical bay enclosure.

  4. Optical Drive Enclosure Faceplate: adım 4, 3 resimden 1. Optical Drive Enclosure Faceplate: adım 4, 3 resimden 2. Optical Drive Enclosure Faceplate: adım 4, 3 resimden 3.
    • Lift the black plastic faceplate out of the optical bay enclosure.

    • You will no longer need the faceplate or the two Phillips screws that held it in place. Set those parts aside if you ever wish to put the faceplate back into the enclosure.

    • Reassemble the optical bay enclosure without the faceplate, reusing the original three 3.0 mm Phillips screws to keep it intact.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Brittany McCrigler

Üyelik tarihi: 03/05/12

89.014 İtibar

131 adet Kılavuz yazıldı

Ekip

iFixit iFixit üyesi

Staff

135 Üyeler

16.816 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 0

Her zaman: 724