Giriş

Guide for removing the Analog stick in a Sony PSP-3000

  1. Place the PSP face down and locate the battery cover on the left side of the device.
    • Place the PSP face down and locate the battery cover on the left side of the device.

    • Lift and remove the battery cover to reveal the battery.

    • Remove the battery.

  2. Peel back the warranty sticker that is behind the battery with a spudger or your fingernail.
    • Peel back the warranty sticker that is behind the battery with a spudger or your fingernail.

    • Unscrew all four screws from the back of the PSP with the Phillips #00 Screwdriver.

      • Two are located behind the battery's warranty sticker.

      • Two are located on the right side of the PSP.

    • Next, unscrew the two screws located at the top of the PSP.

    • Then, remove the single screw from the bottom edge of the PSP (which is positioned next to the barcode).

    • Slide the spudger in between the outer casing of the PSP, beginning at the "R" shoulder button, and gently pry off the casing.


    • Remove the front casing completely.

    • Push the homebar to the right to release the tab located on the right side of the LCD screen.

    • DO NOT completely remove the homebar, as it is still connected by ribbon cables.

    • Slowly lift the LCD screen off the PSP starting at the top edge corner.

    • Again, the LCD screen is attached by ribbon cables, so do not remove it completely.

      • Orientation of PSP is flipped in photo.

    • Flip the small brown locks on the four ribbon cable connectors up using a spudger or fingernail.

    • Pull all four ribbon cables out.

    • Now remove the LCD screen and homebar from the PSP.

    • Remove the metal tab that lies above the LCD screen.

    • Upon reassembly, make note that the stamped lettering faces down, and the large tab fits just above the motherboard to the right hand side of the left trigger.

    • Remove the screw securing 'L' trigger to the PSP.

    • Remove the white plastic piece that holds the 'L' trigger in place.

    • Remove the 'L' trigger from the PSP.

    • Remove the screw securing the 'R' trigger.

    • Remove the white plastic piece that holds the 'R' trigger in place.

    • Remove the 'R' trigger from the PSP.

    • Remove the screw from the bottom left edge of the PSP.

    • Being careful not to break the ribbon cable, use the spudger to peel the adhesive button of the the 'L' trigger off the PSP.

    • Using a fingernail or spudger, flip up the retaining bracket on the d-pad and 'L' trigger ribbon cable.

    • Lift the black plastic bracket along with the d-pad contact pad, disconnecting the ribbon cable as you lift.

    • Remove the cable from the connector and remove the entire black piece from the PSP.

    • Remove the screw holding the analog stick in place.

    • Flip up the lock on the analog sticks ribbon cable.

    • Remove the analog stick from the PSP.

Sonuç

To reassemble your device, follow these instructions in reverse order.

13 başka kişi bu kılavuzu tamamladı.

mbnewsom

Üyelik tarihi: 28-10-2009

2.484 İtibar

11 adet Kılavuz yazıldı

0 Yorum

İstatistikleri Görüntüle:

Son 24 Saat: 8

Son 7 Gün: 41

Son 30 Gün: 164

Her zaman: 18,257