Giriş

This guide will walk you through the process of replacing a bad optical drive in a Packard Bell 4x4 desktop.

Remove the 3 Philips head screws from the back of the computer using your Philips screwdriver.
  • Remove the 3 Philips head screws from the back of the computer using your Philips screwdriver.

Yorum Ekle

Using both hands on each side of the case, slide the top cover toward you. Lift it up off the computer.
  • Using both hands on each side of the case, slide the top cover toward you. Lift it up off the computer.

Yorum Ekle

The top cover is removed.
  • The top cover is removed.

Yorum Ekle

Remove the two Philips head screws with your Philips screwdriver. You may have to lubricate these screws as they can be very difficult to remove.
  • Remove the two Philips head screws with your Philips screwdriver. You may have to lubricate these screws as they can be very difficult to remove.

Yorum Ekle

Remove the 1 Philips head screw from the left hand side of the case if there is one. Again, you may need to lubricate this screw.
  • Remove the 1 Philips head screw from the left hand side of the case if there is one. Again, you may need to lubricate this screw.

Yorum Ekle

Once the screws are removed, disconnect all cables from the optical drive, hard drive and floppy drive.
  • Once the screws are removed, disconnect all cables from the optical drive, hard drive and floppy drive.

Yorum Ekle

Slide the drive cage back. An easy way to do this is the push on the optical drive from the front.
  • Slide the drive cage back. An easy way to do this is the push on the optical drive from the front.

Yorum Ekle

Lift the drive cage up and out of the computer.
  • Lift the drive cage up and out of the computer.

Yorum Ekle

Remove the 1 Philips head screw with your Phillips screwdriver. There should not be a screw in the right hole.
  • Remove the 1 Philips head screw with your Phillips screwdriver. There should not be a screw in the right hole.

Yorum Ekle

Slide the optical drive forward and lift it up from the right side, the side closest to the floppy drive. Slide the optical drive forward and lift it up from the right side, the side closest to the floppy drive.
  • Slide the optical drive forward and lift it up from the right side, the side closest to the floppy drive.

Yorum Ekle

Remove the 2 Philips head screws with your Philips screwdriver. Put these screws onto your new optical drive.
  • Remove the 2 Philips head screws with your Philips screwdriver. Put these screws onto your new optical drive.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

Brandon S

Üyelik tarihi: 04-09-2010

468 İtibar

6 adet Kılavuz yazıldı

Takım

Packard Bell Planet Packard Bell Planet üyesi

Community

1 Üye

6 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 Gün: 1

Son 30 Gün: 1

Her zaman: 439