Giriş

A guide for removing and replacing the phone's microphone.

Position the phone so the screen faces down.
  • Position the phone so the screen faces down.

  • Remove the stylus found on the back of the phone.

Yorum Ekle

To remove the battery cover, hold down the button in the middle of the phone's back.
  • To remove the battery cover, hold down the button in the middle of the phone's back.

  • Slide the cover down to remove. Set the cover aside.

Yorum Ekle

Lift the edge of the battery, separating contact points, and pull out as pictured. Lift the edge of the battery, separating contact points, and pull out as pictured.
  • Lift the edge of the battery, separating contact points, and pull out as pictured.

Yorum Ekle

Remove the small round rubber cover on the back of the phone located immediately below the antenna.
  • Remove the small round rubber cover on the back of the phone located immediately below the antenna.

  • This will uncover a screw that will be removed in the next step.

Yorum Ekle

Unscrew six black 6.9 mm Torx screws with a T5 Torx Screwdriver. Unscrew one 9.75 mm Phillips antenna screw with a Phillips #00 Screwdriver. Pull out antenna.
  • Unscrew six black 6.9 mm Torx screws with a T5 Torx Screwdriver.

  • Unscrew one 9.75 mm Phillips antenna screw with a Phillips #00 Screwdriver.

  • Pull out antenna.

Yorum Ekle

$79,00 ve üstü tüm sparişlerde ücretsiz nakliye.

Mağazamıza Göz Atın
MANTA DRIVER KIT
112 bit driver kit $59.99
MANTA DRIVER KIT
112 bit driver kit $59.99
Pry the back cover off using a spudger or similar tool. The back cover is attached by several small clips on the inside.
  • Pry the back cover off using a spudger or similar tool.

  • The back cover is attached by several small clips on the inside.

Yorum Ekle

Unclip the gray tab. Pull out the orange ribbon cable. Do not remove the motherboard before disconnecting the ribbon cable--Damage may occur!
  • Unclip the gray tab.

  • Pull out the orange ribbon cable.

  • Do not remove the motherboard before disconnecting the ribbon cable--Damage may occur!

Yorum Ekle

Pull off the mother board. Install replacement or repaired motherboard, reversing steps above.
  • Pull off the mother board.

  • Install replacement or repaired motherboard, reversing steps above.

Yorum Ekle

Unscrew the two 3.2 mm screws with a Phillips #00 screwdriver.
  • Unscrew the two 3.2 mm screws with a Phillips #00 screwdriver.

Yorum Ekle

Pull off the circuit board.
  • Pull off the circuit board.

Yorum Ekle

Remove the keypad for cleaning or replacing.
  • Remove the keypad for cleaning or replacing.

Yorum Ekle

Place the circuit board with the microphone facing up.
  • Place the circuit board with the microphone facing up.

Yorum Ekle

The microphone should be able to pop off easily using your finger. The microphone should be able to pop off easily using your finger.
  • The microphone should be able to pop off easily using your finger.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

cgood

Üyelik tarihi: 28-10-2009

116 İtibar

14 adet Kılavuz yazıldı

Takım

Cal Poly, Team 19-3, Maness Fall 2009 Cal Poly, Team 19-3, Maness Fall 2009 üyesi

CPSU-MANESS-F09S19G3

4 Üye

18 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 1

Tüm Zamanlar: 4,362