Using a T5 Torx screwdriver, unscrew the two 5mm screws located at the bottom of the device. Using a T5 Torx screwdriver, unscrew the two 5mm screws located at the bottom of the device.
  • Using a T5 Torx screwdriver, unscrew the two 5mm screws located at the bottom of the device.

Yorum Ekle

Peel back the adhesive label below the camera on the rear to reveal a hidden screw, circled in the picture to the left.
  • Peel back the adhesive label below the camera on the rear to reveal a hidden screw, circled in the picture to the left.

    • If you peel the entire adhesive off, two holes underneath will be exposed to future damage. Try to preserve the label to reapply later.

    • Alternate Procedure: Underneath the camera, feel for a depression and cut the sticker directly above the depression to reveal the hidden screw.

Yorum Ekle

Use a #00 Philips screwdriver to remove the 2.5mm hidden screw.
  • Use a #00 Philips screwdriver to remove the 2.5mm hidden screw.

Yorum Ekle

Use either end of the spudger to carefully pry off the camera lens mesh cover.
  • Use either end of the spudger to carefully pry off the camera lens mesh cover.

Yorum Ekle

Using the #00 Phillips screwdriver, remove the two 9mm screws on the top corners of the device.
  • Using the #00 Phillips screwdriver, remove the two 9mm screws on the top corners of the device.

Yorum Ekle

Spin the phone around so that the headphone jack is facing you. Run the flat end of the spudger around the entire edge of the device to gently pry the case off. Gently remove the case to avoid damaging it. Do not try to force the case open.
  • Spin the phone around so that the headphone jack is facing you. Run the flat end of the spudger around the entire edge of the device to gently pry the case off.

    • Gently remove the case to avoid damaging it. Do not try to force the case open.

    • The L shaped latches located on the bottom of the device make it hard to remove the case; you should run the spudger around the device's edges again if you are having problems.

Yorum Ekle

Remove the cover by lifting it from right to left. This should be similar to the action of the opening of a book.
  • Remove the cover by lifting it from right to left.

    • This should be similar to the action of the opening of a book.

    • The brown film connecting the motherboard to the screen may tear if this is not done carefully.

Yorum Ekle

Lift the control pad buttons off of the motherboard.
  • Lift the control pad buttons off of the motherboard.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Michelle Medina

Üyelik tarihi: 10-04-2012

63 İtibar

10 adet Kılavuz yazıldı

Takım

Cal Poly, Team 6-49, Amido Spring 2012 Cal Poly, Team 6-49, Amido Spring 2012 üyesi

CPSU-AMIDO-S12S6G49

4 Üyeler

10 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 0

Her zaman: 300