Giriş

This guide will show the user how to disassemble the camera to reach the Flash Top Assembly. Once the Flash Top Assembly is reached, the user can replace it.

Parçalar

Hiçbir parçaya gerek yok.

  1. Locate the memory card and battery card latch on the bottom of the camera.
    • Locate the memory card and battery card latch on the bottom of the camera.

    • Slide the latch to the open position.

  2. Open the battery latch, and slide the battery release lever to the right.
    • Open the battery latch, and slide the battery release lever to the right.

    • Remove the battery from the camera.

    • Using a size #00 Phillips screwdriver, remove the three 4.58 mm screws on the bottom of the camera.

    • Use this screwdriver for all screws in the device.

    • Remove the 3.15 mm screw on the left side of the camera.

    • Remove the left side casing.

    • Remove the two 3.15 mm screws on the right side of the camera.

    • Remove the bottom right panel.

    • Gently remove the back casing.

    • Start at the bottom and carefully pry towards the top to get this piece free.

    • Carefully pry the Flash Top Assembly away from the top.

    • Replace the Flash Top Assembly with a new one.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Caleb Fink

Üyelik tarihi: 11-10-2010

186 İtibar

2 adet Kılavuz yazıldı

Takım

Cal Poly, Team 9-22, Regan Fall 2010 Cal Poly, Team 9-22, Regan Fall 2010 üyesi

CPSU-REGAN-F10S9G22

4 Üyeler

8 adet Kılavuz yazıldı

0 Yorum

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 Gün: 2

Son 30 Gün: 4

Her zaman: 3,523