Ana içeriğe geç

Giriş

A digitizer cable is important to the camera as it sends the display signals to the camera screen from the motherboard. It is vital for both camera operation and a live view of the lens.

  1. Power off your device by locating the on/off switch on top of camera.
    • Power off your device by locating the on/off switch on top of camera.

  2. Remove the screw located on the right side of the camera. Remove the screw located on the bottom right of the camera, and remove the cover from the camera. Remove the screw located on the bottom right of the camera, and remove the cover from the camera.
    • Remove the screw located on the right side of the camera.

    • Remove the screw located on the bottom right of the camera, and remove the cover from the camera.

  3. Remove the screw located on the base of the camera.
    • Remove the screw located on the base of the camera.

  4. MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now

    MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now
  5. Pry the top part of the camera slowly. Be careful not to tear the digitilizer cable.
    • Pry the top part of the camera slowly. Be careful not to tear the digitilizer cable.

  6. Open the bigger clamp using a spudger or other tools. Repeat for the smaller clamp. Open the bigger clamp using a spudger or other tools. Repeat for the smaller clamp.
    • Open the bigger clamp using a spudger or other tools. Repeat for the smaller clamp.

  7. Carefully take the thin ribbon and insert cable end into the latch. Do this for both sides. Carefully take the thin ribbon and insert cable end into the latch. Do this for both sides.
    • Carefully take the thin ribbon and insert cable end into the latch. Do this for both sides.

  8. Once the ribbon is placed into the latch, carefully close the clamps by lowering the clamp into a down position. Repeat this step for both sides. Once the ribbon is placed into the latch, carefully close the clamps by lowering the clamp into a down position. Repeat this step for both sides. Once the ribbon is placed into the latch, carefully close the clamps by lowering the clamp into a down position. Repeat this step for both sides.
    • Once the ribbon is placed into the latch, carefully close the clamps by lowering the clamp into a down position. Repeat this step for both sides.

Sonuç

To reassemble your device, follow these instructions in reverse order.

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 0

Her zaman: 49