Ana içeriğe geç

Fix Your Stuff

Right to Repair

Parts & Tools

Giriş

These steps will guide to simply replace your camera's screen.

  1. Open the four 3.40 mm screws from the right and left sides of your Panasonic Lumix Camera. Remove the two 2.60 mm screws located next to the battery. Remove the two 2.60 mm screws located next to the battery.
    • Open the four 3.40 mm screws from the right and left sides of your Panasonic Lumix Camera.

    • Remove the two 2.60 mm screws located next to the battery.

  2. Use the plastic opening tool to open the outer cover of your device from the HDMI port.
    • Use the plastic opening tool to open the outer cover of your device from the HDMI port.

    • Open it carefully to avoid breaking the cover.

  3. Use a spudger to carefully detach the ribbon cable without breaking it. Use a spudger to carefully detach the ribbon cable without breaking it. Use a spudger to carefully detach the ribbon cable without breaking it.
    • Use a spudger to carefully detach the ribbon cable without breaking it.

  4. Use the plastic opening tool to lift and remove the buttons board as shown.
    • Use the plastic opening tool to lift and remove the buttons board as shown.

  5. Carefully lift the screen using the plastic opening tool as shown. Carefully lift the screen using the plastic opening tool as shown.
    • Carefully lift the screen using the plastic opening tool as shown.

Sonuç

To reassemble your device, follow these instructions in reverse order.

3 farklı kişi bu kılavuzu tamamladı.

Abbas Khan

Üyelik tarihi: 21-01-2015

482 İtibar

4 adet Kılavuz yazıldı

Takım

USF Tampa, Team 9-5, Brown Winter 2015 USF Tampa, Team 9-5, Brown Winter 2015 üyesi

USFT-BROWN-W15S9G5

3 Üyeler

5 adet Kılavuz yazıldı

Bir Yorum

- Of the two 2.60 mm screws on the bottom of the camera, only the one closest to the back needs to be removed.

- The correct screwdriver is JIS Type S #00. A Phillips driver can ruin the screws.

- The screen shown in step 5 consists of two parts: the LCD and a frame. The replacement LCD that I ordered came without the frame, so a little more disassembly was required, including a bit of delicate soldering: the narrow ribbon cable is really two cables, soldered together. The solder joints are hidden under the piece of black electric tape at the end.

nasorenga - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 gün: 3

Son 30 gün: 13

Her zaman: 3,918