Ana içeriğe geç

Giriş

This guide will walk you through steps to replace your joystick.

  1. Total of 6 Screws are located in the back of the controller.
    • Total of 6 Screws are located in the back of the controller.

    • Four 0.9mm T6 screws

    • Two 0.1mm T6 screws

    • Flip the Flypad over.

    • Remove the six screws using a T6 screwdriver.

    • Use a Magnetic Mat to prevent loss of screws. Set aside.

  2. Flip the Flypad over again and separate the front and back. Be sure to remove the foam adhesive that connects the front plate to the motherboard.
    • Flip the Flypad over again and separate the front and back. Be sure to remove the foam adhesive that connects the front plate to the motherboard.

    • Be aware that the Buttons (L1,R1) may fall out. Remember to put them back in place during reassembly.

    • Use Ph0 tool to remove the screws holding the motherboard in place.

    • Gently remove the motherboard from the front plate.

  3. iPhone Pil Tamir Setleri

    Only $29.99

    Buy Now

    iPhone Pil Tamir Setleri

    Only $29.99

    Buy Now
  4. Pop the joysticks out by pulling gently. Pop the joysticks out by pulling gently.
    • Pop the joysticks out by pulling gently.

  5. Unscrew and replace joystick caps for a more comfortable grip.
    • Unscrew and replace joystick caps for a more comfortable grip.

Sonuç

To reassemble your device, follow these instructions in reverse order.

HUY NGUYEN

Üyelik tarihi: 10-04-2017

352 İtibar

3 adet Kılavuz yazıldı

Takım

UW Tacoma, Team S3-G5, Liner Spring 2017 UW Tacoma, Team S3-G5, Liner Spring 2017 üyesi

UWT-LINER-S17S3G5

5 Üyeler

3 adet Kılavuz yazıldı

Bir Yorum

Do you know where I can find replacement joystick caps like the one shown in Step 4, please?

cbeilstein - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 1

Son 30 Gün: 9

Her zaman: 349