Giriş

You will be taking the wheel off of your bike, removing the tire from the wheel, and patching the hole.

Notes:

  • Make sure that the wheel is fully deflated throughout the process, except for finding the hole.
  • When applying the rubber cement to the hole, the thinner the layer the better, for faster drying.
Flip the quick release lever on the wheel.
  • Flip the quick release lever on the wheel.

Yorum Ekle

Squeeze the brake arms together and lift the brake cable from the caliper arms.
  • Squeeze the brake arms together and lift the brake cable from the caliper arms.

Yorum Ekle

  • Hold the wheel to the ground, and pull the bike frame up and away to remove the wheel from the bike.

Yorum Ekle

  • Press the valve core while applying pressure to the tire to deflate the tire.

Yorum Ekle

  • Insert the flat part of a tire lever under the tire coping. Apply pressure to the other end of the lever to lift the tire up and out of the wheel.

  • Slide the lever around the circumference of the wheel to completely remove the tire.

    • Alternatively, if you have multiple tire levers, see if you can clip the first lever to a spoke to keep it in place. Then insert the second lever a few inches away. Clip it to a spoke. Insert the third lever a few more inches along. Take out the second lever and insert it it a few inches past the third. Work along the rim until the tire pops off.

Yorum Ekle

  • Remove the tube by pushing the valve through the hole in the rim and pulling the tube out from under the tire.

Yorum Ekle

  • Press the valve core while applying pressure to the tire to deflate the tire.

Yorum Ekle

  • Insert the flat part of a tire lever under the tire coping. Apply pressure to the other end of the lever to lift the tire up and out of the wheel.

  • Slide the lever around the circumference of the wheel to completely remove the tire.

Yorum Ekle

  • Remove the tube by pushing the valve through the hole in the rim and pulling out completely.

Yorum Ekle

  • Locate the leak by first over inflating the tire.

  • Place the tire under water and look for bubbles to find the leak.

Yorum Ekle

  • Mark the hole with a marker, and completely deflate the tire.

Yorum Ekle

  • Select a patch kit that you will use to patch the hole. Try to pick a patch that is appropriate for the size of the hole.

Yorum Ekle

  • Clean the area near the hole with soap and water, then dry it thoroughly.

  • Rough up the area around the hole with an abrasive surface such as sand paper until the area around the leak loses its shine.

Yorum Ekle

  • Apply rubber cement to an area around the hole that is bigger than the patch to ensure that the patch bonds completely.

Yorum Ekle

  • Apply the patch to the area.

Yorum Ekle

  • Apply pressure to the patch until the rubber cement is dry.

Yorum Ekle

Sonuç

To reassemble your wheel, follow these instructions in reverse order starting at step three.

6 başka kişi bu kılavuzu tamamladı.

Travis Tonder

Üyelik tarihi: 05-10-2010

2.507 İtibar

4 adet Kılavuz yazıldı

Takım

Cal Poly, Team 5-13, Maness Fall 2010 Cal Poly, Team 5-13, Maness Fall 2010 üyesi

CPSU-MANESS-F10S5G13

4 Üyeler

11 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 7

Her zaman: 3,872