Eşyalarını Tamir Et Topluluk Mağaza

Philips BiPAP S/T Blower Replacement

Tıbbi Ekipman
iFixit de, bu onarım kılavuzu da tıbbi cihaz üreticisi tarafından onaylanmış değildir ya da herhangi birinin üreticiyle alâkası yoktur.

Giriş

Under high usage the blower assembly is under a large amount of stress causing the whole unit to malfunction. Thus, needing to replace the whole blower.

For more information on replacing the blower assembly, please refer to page 6-16 in the service manual.

Neye ihtiyacın var

Videoya Genel Bakış

  1. Philips BiPAP S/T Blower Replacement, Blower: adım 1, 1 resimden 1.

    • Remove the UI Knob by pulling it straight out.

    Düzenle

  2. Philips BiPAP S/T Blower Replacement: adım 2, 1 resimden 1.

    • Remove the top cover by using a Torx T15 to remove the 2 screws on the back of the enclosure.

    Düzenle

  3. Philips BiPAP S/T Blower Replacement: adım 3, 1 resimden 1.

    • Remove the Main PCA by removing the wiring harnesses and squeezing the 2 standoffs in the corners of the board.

    Düzenle

  4. Philips BiPAP S/T Blower Replacement: adım 4, 1 resimden 1.

    • Remove the Blower Cap by using the T8 Torx screwdriver to remove the 7 screws that secure the Cap to the enclosure.

    Düzenle

    • Lift the Blower Assembly out of the blower housing.

    • Remove the blower Outlet Bellows from the blower assembly.

    Düzenle

    • Place the New outlet bellows onto the blower assembly.

    Düzenle

  7. Philips BiPAP S/T Blower Replacement: adım 7, 1 resimden 1.

    • Align the stands located on the bottom of the blower assembly with the holes in the blower housing.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

2 farklı kişi bu kılavuzu tamamladı.

Yazar

2 tane daha katılımcı ile

Benjamin LaVigna

Üyelik tarihi: 04/07/20

243 İtibar

1 Kılavuz yazıldı

Rozetler: 5

+2 tane daha rozet

Ekip

Cal Poly, Team S7-G3, Paton Spring 2020 Cal Poly, Team S7-G3, Paton Spring 2020 üyesi

CPSU-PATON-S20S7G3

3 Üyeler

3 adet Kılavuz yazıldı

Bir Yorum

this was super helpful. i yanked a working motor/blower from a slightly older system one unit that had a dead humidifier circuit(found it had melted the connector inside) and moved it to my newer bipap unit. works great, dead silent. mine had bad bearings…so loud. great article. thank you for saving me money, time…..SLEEP!

Jon Harmon - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 8

Son 30 gün: 24

Her zaman: 2,738