Giriş

Follow the procedure outlined in this guide to remove and install a broken iPhone/iPod connector.

Pry off the four white feet with the pointed end of the spudger
  • Pry off the four white feet with the pointed end of the spudger

Yorum Ekle

Unscrew the four 15.5 mm Phillips #2 screws that hold the bottom panel to the dock.
  • Unscrew the four 15.5 mm Phillips #2 screws that hold the bottom panel to the dock.

Yorum Ekle

Use the flat end of the spudger to pry the lid off from the two connectors holding it to the body of the dock.
  • Use the flat end of the spudger to pry the lid off from the two connectors holding it to the body of the dock.

  • The connectors on the panel are fragile and may break.

Yorum Ekle

Carefully pull up and out the four electrical connectors and the two ribbon connectors connecting the bottom panel and the dock. Electrical Connectors Ribbon Connectors
  • Carefully pull up and out the four electrical connectors and the two ribbon connectors connecting the bottom panel and the dock.

    • Electrical Connectors

    • Ribbon Connectors

  • The cables do not have a lot of slack in them. Be careful not to break the connectors.

  • One wire is soldered onto the bottom panel. Be careful not to break this bond.

Yorum Ekle

Pull the copper plate out of the way of the two Phillips #00 screws in the middle of the connector.
  • Pull the copper plate out of the way of the two Phillips #00 screws in the middle of the connector.

Yorum Ekle

Unscrew the two 7 mm Phillips #00 screws holding the connector together.
  • Unscrew the two 7 mm Phillips #00 screws holding the connector together.

  • Unscrew the four 5 mm Phillips #00 screws holding the connector to the dock

Yorum Ekle

Turn the dock so that you are looking at the front of the dock. Pull out the black U-shaped piece. Pull out the iPhone/iPod support cradle.
  • Turn the dock so that you are looking at the front of the dock.

  • Pull out the black U-shaped piece.

  • Pull out the iPhone/iPod support cradle.

  • Pull out the two springs.

Yorum Ekle

Turn the dock so that you are looking at the bottom of the dock.
  • Turn the dock so that you are looking at the bottom of the dock.

  • Pop out the black connector frame and attached circuit board from the body of the dock.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Greg Lane

Üyelik tarihi: 16-04-2013

9 İtibar

4 adet Kılavuz yazıldı

Takım

Cal Poly, Team 3-48, Amido Spring 2013 Cal Poly, Team 3-48, Amido Spring 2013 üyesi

CPSU-AMIDO-S13S3G48

4 Üyeler

6 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 1

Son 30 Gün: 6

Her zaman: 866