Giriş

Follow the procedure in this guide to remove and install a broken LCD screen.

Pry off the four white feet with the pointed end of the spudger
  • Pry off the four white feet with the pointed end of the spudger

Yorum Ekle

Unscrew the four 15.5 mm Phillips #2 screws that hold the bottom panel to the dock.
  • Unscrew the four 15.5 mm Phillips #2 screws that hold the bottom panel to the dock.

Yorum Ekle

Use the flat end of the spudger to pry the lid off from the two connectors holding it to the body of the dock.
  • Use the flat end of the spudger to pry the lid off from the two connectors holding it to the body of the dock.

  • The connectors on the panel are fragile and may break.

Yorum Ekle

Carefully pull up and out the four electrical connectors and the two ribbon connectors connecting the bottom panel and the dock. Electrical Connectors Ribbon Connectors
  • Carefully pull up and out the four electrical connectors and the two ribbon connectors connecting the bottom panel and the dock.

    • Electrical Connectors

    • Ribbon Connectors

  • The cables do not have a lot of slack in them. Be careful not to break the connectors.

  • One wire is soldered onto the bottom panel. Be careful not to break this bond.

Yorum Ekle

Unscrew the two 6 mm Phillips #00 screws attaching the back panel to device.
  • Unscrew the two 6 mm Phillips #00 screws attaching the back panel to device.

Yorum Ekle

Slide the back panel towards top of the device and lift away from the device to detach back panel. Slide the back panel towards top of the device and lift away from the device to detach back panel. Slide the back panel towards top of the device and lift away from the device to detach back panel.
  • Slide the back panel towards top of the device and lift away from the device to detach back panel.

Yorum Ekle

Unscrew the four 16 mm Phillips #2 screws attaching the speaker unit to device.
  • Unscrew the four 16 mm Phillips #2 screws attaching the speaker unit to device.

Yorum Ekle

Slide the speaker towards the bottom of the device to remove. Slide the speaker towards the bottom of the device to remove.
  • Slide the speaker towards the bottom of the device to remove.

Yorum Ekle

Unscrew the seven 6 mm Phillips #00 screws holding the grey side piece to the black front panel. Five of the Phillips #00 screws are on the LCD board. The other two are on the dock's bottom circuit board. Unscrew the two 8 mm Phillips #1 screws that go through the grey piece and the LCD motherboard.
  • Unscrew the seven 6 mm Phillips #00 screws holding the grey side piece to the black front panel.

    • Five of the Phillips #00 screws are on the LCD board. The other two are on the dock's bottom circuit board.

  • Unscrew the two 8 mm Phillips #1 screws that go through the grey piece and the LCD motherboard.

Yorum Ekle

Remove the ribbon cable from the ZIF connector by pulling out the two black tabs with the pointed end of the spudger then pulling the cable straight out of the connector.
  • Remove the ribbon cable from the ZIF connector by pulling out the two black tabs with the pointed end of the spudger then pulling the cable straight out of the connector.

Yorum Ekle

Remove the grey side piece from the black front panel by pulling it straight up. It should easily slide off. Remove the grey side piece from the black front panel by pulling it straight up. It should easily slide off.
  • Remove the grey side piece from the black front panel by pulling it straight up. It should easily slide off.

Yorum Ekle

Unscrew the six 8 mm Phillips #1 screws holding the LCD screen to the black front panel. Unscrew the two 6 mm Phillips #00 screws from the top of the panel holding the the LCD screen to the front panel.
  • Unscrew the six 8 mm Phillips #1 screws holding the LCD screen to the black front panel.

  • Unscrew the two 6 mm Phillips #00 screws from the top of the panel holding the the LCD screen to the front panel.

  • Pull the LCD and circuit board off of the front panel.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Greg Lane

Üyelik tarihi: 16-04-2013

9 İtibar

4 adet Kılavuz yazıldı

Takım

Cal Poly, Team 3-48, Amido Spring 2013 Cal Poly, Team 3-48, Amido Spring 2013 üyesi

CPSU-AMIDO-S13S3G48

4 Üyeler

6 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 11

Son 30 Gün: 24

Tüm Zamanlar: 929