Giriş

Follow the procedure outlined in this guide to remove and install a speaker.

Pry off the four white feet with the pointed end of the spudger
  • Pry off the four white feet with the pointed end of the spudger

Yorum Ekle

Unscrew the four 15.5 mm Phillips #2 screws that hold the bottom panel to the dock.
  • Unscrew the four 15.5 mm Phillips #2 screws that hold the bottom panel to the dock.

Yorum Ekle

Use the flat end of the spudger to pry the lid off from the two connectors holding it to the body of the dock.
  • Use the flat end of the spudger to pry the lid off from the two connectors holding it to the body of the dock.

  • The connectors on the panel are fragile and may break.

Yorum Ekle

Carefully pull up and out the four electrical connectors and the two ribbon connectors connecting the bottom panel and the dock. Electrical Connectors Ribbon Connectors
  • Carefully pull up and out the four electrical connectors and the two ribbon connectors connecting the bottom panel and the dock.

    • Electrical Connectors

    • Ribbon Connectors

  • The cables do not have a lot of slack in them. Be careful not to break the connectors.

  • One wire is soldered onto the bottom panel. Be careful not to break this bond.

Yorum Ekle

Unscrew the two 6 mm Phillips #00 screws attaching the back panel to device.
  • Unscrew the two 6 mm Phillips #00 screws attaching the back panel to device.

Yorum Ekle

Slide the back panel towards top of the device and lift away from the device to detach back panel. Slide the back panel towards top of the device and lift away from the device to detach back panel. Slide the back panel towards top of the device and lift away from the device to detach back panel.
  • Slide the back panel towards top of the device and lift away from the device to detach back panel.

Yorum Ekle

Unscrew the four 16 mm Phillips #2 screws attaching the speaker unit to device.
  • Unscrew the four 16 mm Phillips #2 screws attaching the speaker unit to device.

Yorum Ekle

Slide the speaker towards the bottom of the device to remove. Slide the speaker towards the bottom of the device to remove.
  • Slide the speaker towards the bottom of the device to remove.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Graham Rolph

Üyelik tarihi: 18-04-2013

1 İtibar

2 adet Kılavuz yazıldı

Takım

Cal Poly, Team 3-48, Amido Spring 2013 Cal Poly, Team 3-48, Amido Spring 2013 üyesi

CPSU-AMIDO-S13S3G48

4 Üyeler

6 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 1

Son 30 Gün: 3

Her zaman: 537