Ana içeriğe geç
  1. Philips Pressurised Steam Generator Iron GC8220 and Similar Models' Temperature Sensor (NTC Thermistor) Replacement, Temperature Sensor (NTC Thermistor): adım 1, 1 resimden 1.
    • The Temperature Sensor is attached to the bottom of the Boiler unit.

    • It is an NTC Thermistor.

  2. Philips Pressurised Steam Generator Iron GC8220 and Similar Models' Temperature Sensor (NTC Thermistor) Replacement: adım 2, 1 resimden 1.
    • It is connected to the Main PCB.

  3. Philips Pressurised Steam Generator Iron GC8220 and Similar Models' Temperature Sensor (NTC Thermistor) Replacement: adım 3, 1 resimden 1.
    • It looks like a diode. But it is a resistor that changes value with temperature.

  4. Philips Pressurised Steam Generator Iron GC8220 and Similar Models' Temperature Sensor (NTC Thermistor) Replacement: adım 4, 1 resimden 1.
    • They come in a range of values. 10kOhms ~ 100 kOhms.

Sonuç

To reassemble your device, follow these instructions in reverse order.

4 farklı kişi bu kılavuzu tamamladı.

Omid

Üyelik tarihi: 23-07-2017

220 İtibar

1 Kılavuz yazıldı

4 Comments

With GC9640 the termistor is 226 kOhm @ 26°C.

Beim GC9640 hat der NTC 226 kOhm bei 26°C

John Maier - Yanıt

My Philips GC 9245 after ironing found water on the shirts, and the iron heat is not like as hot as in the past, is this cause by the Temperature Sensor (NTC Thermistor) ?

lylim_ly - Yanıt

With GC9220 model, résistance of boiler CTN : around 300k à 15°C, decreasing slowly to 160K at around 30°C, I didn’t test with other temperature.

Nico Land - Yanıt

Hi all , Does anyone know how much should be the resistance on ohm of the boiler of Philips iron steamer GC9241.Thanks

Nikos Sapranidis - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 9

Son 7 gün: 49

Son 30 gün: 144

Her zaman: 5,013