Ana içeriğe geç

Giriş

Water damage or a faulty electrical opponent may make the Pioneer Elite Pro-R06U shut off intermittently or fail to power on. Removing the faulty board and installing a new one should get the receiver back up and running.

Parçalar

Hiçbir parça belirtilmedi.

  1. Remove the two 6.4 mm Phillips screws on each side of the device's casing.
    • Remove the two 6.4 mm Phillips screws on each side of the device's casing.

  2. Remove the three 6.5 mm Phillips screws on the back of the device casing.
    • Remove the three 6.5 mm Phillips screws on the back of the device casing.

  3. MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now

    MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now
  4. Grip the front panel in one hand and the back of the casing in the other. Pull the casing back, and slide it up and away from the inner box.
    • Grip the front panel in one hand and the back of the casing in the other. Pull the casing back, and slide it up and away from the inner box.

  5. Gently pull upward and unplug cables D4 and D5.
    • Gently pull upward and unplug cables D4 and D5.

  6. Remove the two 7/16 inch Phillips screws to the left and right of the power supply port.
    • Remove the two 7/16 inch Phillips screws to the left and right of the power supply port.

    • Remove three 5/16 inch Phillips screws from the corners of the board.

  7. Remove the power supply board by pulling it toward the interior of the device then lifting.
    • Remove the power supply board by pulling it toward the interior of the device then lifting.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Cody Carter

Üyelik tarihi: 30-01-2018

1.049 İtibar

6 adet Kılavuz yazıldı

Takım

Baylor, Team S1-G5, Johnson Spring 2018 Baylor, Team S1-G5, Johnson Spring 2018 üyesi

BU-JOHNSON-S18S1G5

3 Üyeler

6 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 6

Her zaman: 166