Ana içeriğe geç

Giriş

This guide will show you how to locate and replace the fan in the PlayStation 2 Slimline.

Parçalar

Hiçbir parça belirtilmedi.

  1. PlayStation 2 Slimline Fan Replacement, Outer Shell: step 1, image 1 of 1
    • Disconnect all cables from the console and flip the unit over to reveal its base.

  2. PlayStation 2 Slimline Fan Replacement: step 2, image 1 of 3 PlayStation 2 Slimline Fan Replacement: step 2, image 2 of 3 PlayStation 2 Slimline Fan Replacement: step 2, image 3 of 3
    • Locate the 6 feet on the base of the unit. Pry them off using a spudger to reveal the screws.

    • Note: One of the feet is located under the sticker shown in the photo. Removing this sticker will void any warranty with Sony.

  3. PlayStation 2 Slimline Fan Replacement: step 3, image 1 of 3 PlayStation 2 Slimline Fan Replacement: step 3, image 2 of 3 PlayStation 2 Slimline Fan Replacement: step 3, image 3 of 3
    • Remove all six 4.0 mm screws from the base of the unit using a #1 Phillips screwdriver.

  4. PlayStation 2 Slimline Fan Replacement: step 4, image 1 of 3 PlayStation 2 Slimline Fan Replacement: step 4, image 2 of 3 PlayStation 2 Slimline Fan Replacement: step 4, image 3 of 3
    • Starting at the corner at which the power and Ethernet ports are located, pry open the outer shell using a spudger and continue around the entire unit.

    • Note: You may use your hands for additional force to separate the two pieces of the outer shell.

  5. PlayStation 2 Slimline Fan Replacement, Fan: step 5, image 1 of 2 PlayStation 2 Slimline Fan Replacement, Fan: step 5, image 2 of 2
    • Locate the fan at the front, left section of the unit.

  6. PlayStation 2 Slimline Fan Replacement: step 6, image 1 of 2 PlayStation 2 Slimline Fan Replacement: step 6, image 2 of 2
    • Peel off the sticker holding the power cords to the unit.

  7. PlayStation 2 Slimline Fan Replacement: step 7, image 1 of 2 PlayStation 2 Slimline Fan Replacement: step 7, image 2 of 2
    • Lift the connector from the motherboard with a pair of tweezers using a firm, upward force.

  8. PlayStation 2 Slimline Fan Replacement: step 8, image 1 of 3 PlayStation 2 Slimline Fan Replacement: step 8, image 2 of 3 PlayStation 2 Slimline Fan Replacement: step 8, image 3 of 3
    • Remove all three 1.6 mm screws fastening the fan to the unit using a #1 Phillips screwdriver.

    • Gently lift and remove the fan from its compartment.

Sonuç

To reassemble your device, follow these instructions in reverse order.

9 farklı kişi bu kılavuzu tamamladı.

Thomas Sullivan

Üyelik tarihi: 23-10-2013

3.384 İtibar

6 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 gün: 22

Son 30 gün: 137

Her zaman: 5,751