Ana içeriğe geç
Onarım Topluluğuna Katılın - Hesap Oluşturun

Pokewalker Button Replacement

Neye ihtiyacın var

  1. Pokewalker Button Replacement, Battery: adım 1, 1 resimden 1.
    • Locate the Screw on the Back of the Pokewalker.

    FixBot'a Sor
  2. Pokewalker Button Replacement: adım 2, 1 resimden 1.
    • Remove the Screw with a Phillips #0 Screwdriver

    • The screw is attached to the rear case with washers. don't worry about losing it.

    FixBot'a Sor
  3. Pokewalker Button Replacement: adım 3, 1 resimden 1.
    • Remove the Rear Cover from the Device

    FixBot'a Sor
  4. Pokewalker Button Replacement: adım 4, 1 resimden 1.
    • Use the flat end of a Spudger to Remove the Battery

    FixBot'a Sor
    • Locate the 4 Screws Around the Device

    FixBot'a Sor
    • Remove all 4 screws with a Y0 Triwing Screwdriver

    FixBot'a Sor
    • Separate the 2 halves of the Device

    • Do not Separate Completely as the Display is Still Connected by a Ribbon Cable

    FixBot'a Sor
  5. Bu adımda kullanılan alet:
    Tweezers
    $4.99
    • Use a Spudger to Flip the Latch holding the ribbon cable in place and use Tweezers to Pull it out

    • Do not use Excessive force when reinserting the cable, because ribbon cables are fragile

    FixBot'a Sor
    • Remove the Rubber-button thingy from the upper case

    • I have no idea what that thing is, edit this guide if you do.

    FixBot'a Sor
    • Remove the 3 Plastic Buttons from the Case

    • It helps that the buttons only go in one way, makes it easier to reassemble

    FixBot'a Sor
Sonuç

To reassemble your device, follow these instructions in reverse order.

Winni Stuart

Üyelik tarihi: 04/13/14

447 İtibar

2 adet Kılavuz yazıldı

0Kılavuz Yorumları

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 3

Son 7 gün: 14

Son 30 gün: 80

Her zaman: 1,150