Giriş

Replacing a broken or scratched lens on a Polaroid Sun 600 LMS.

  1. Move film door slide on the left side of camera forward.
    • Move film door slide on the left side of camera forward.

    • Pull film door open.

    Yorum Ekle

  2. Open the flash assembly by holding the sides of the top piece of the camera and pushing up gently until it snaps into place.
    • Open the flash assembly by holding the sides of the top piece of the camera and pushing up gently until it snaps into place.

    • If your camera is old or dirty, it may take more force to open the flash assembly.

    Yorum Ekle

  3. Free shipping on orders over $20
    Use code BLUEANDBLACK at checkout
    Free shipping on orders over $20
    Use code BLUEANDBLACK
    • Use a spudger on each side to separate the flash segment from the main body.

    • Be careful not to do this too hard because you may pull out the connecting wires.

    Yorum Ekle

    • Use several plastic opening tools around the edges of the camera's body to separate it from the plastic frame.

    Yorum Ekle

    • Place left hand on the gray section and right hand on the black section.

    • Pull the sections apart.

    Yorum Ekle

    • Carefully remove the damaged lens from the interior of the camera.

    • Replace with a new lens.

    Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

Ian Hosek

Üyelik tarihi: 20-01-2010

345 İtibar

1 Kılavuz yazıldı

Takım

Cal Poly, Team 3-18, Maness Winter 2010 Cal Poly, Team 3-18, Maness Winter 2010 üyesi

CPSU-MANESS-W10S3G18

4 Üyeler

4 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 2

Son 7 Gün: 12

Son 30 Gün: 48

Her zaman: 7,758