Eşyalarını Tamir Et Topluluk Mağaza

Power Mac G5 CD-ROM Drive Replacement

Giriş

Use this guide to replace the CD-ROM drive in your Power Mac G5.

  1. Power Mac G5 CD-ROM Drive Replacement, Side Panel: adım 1, 1 resimden 1.

    • To avoid electrocution, shut down the computer. Do not open the computer or attempt to install any items inside it while the computer is on.

    • To avoid being burned, wait at least 10 minutes to allow the computer's internal components to cool.

    Düzenle

  2. Power Mac G5 CD-ROM Drive Replacement: adım 2, 1 resimden 1.

    • Remove all the cables, including the power cables before opening the unit.

    Düzenle

  3. Power Mac G5 CD-ROM Drive Replacement: adım 3, 2 resimden 1. Power Mac G5 CD-ROM Drive Replacement: adım 3, 2 resimden 2.

    • Lift the tab to unlock the side panel.

    • The panel should fall out. If the panel does not fall out by itself pull a little from the edges.

    Düzenle

  5. Power Mac G5 CD-ROM Drive Replacement: adım 4, 3 resimden 1. Power Mac G5 CD-ROM Drive Replacement: adım 4, 3 resimden 2. Power Mac G5 CD-ROM Drive Replacement: adım 4, 3 resimden 3.

    • Remove the air deflector (the clear plastic cover) by pulling on the handle.

    Düzenle

  6. Power Mac G5 CD-ROM Drive Replacement, CD-ROM Drive: adım 5, 1 resimden 1.

    • Locate the CD-ROM Drive on the top left corner of desktop.

    Düzenle

  7. Power Mac G5 CD-ROM Drive Replacement: adım 6, 3 resimden 1. Power Mac G5 CD-ROM Drive Replacement: adım 6, 3 resimden 2. Power Mac G5 CD-ROM Drive Replacement: adım 6, 3 resimden 3.

    • Pull and rotate latches to the left.

    Düzenle

  8. Power Mac G5 CD-ROM Drive Replacement: adım 7, 1 resimden 1.

    • Wiggle and pull out the CD Drive.

    Düzenle

  9. Power Mac G5 CD-ROM Drive Replacement: adım 8, 2 resimden 1. Power Mac G5 CD-ROM Drive Replacement: adım 8, 2 resimden 2.

    • Detach the first cable from the CD-ROM drive.

    • Detach the second cable from the CD-ROM drive.

    • On some models, the IDE cable is stuck to the top of the CD-ROM with foam tape. It is easier to unplug the IDE connector from the motherboard, and de-route the IDE cable as you remove the drive.

    Düzenle

  10. Power Mac G5 CD-ROM Drive Replacement: adım 9, 1 resimden 1.

    • After the CD-ROM drive is removed, the area should look like this.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

43 farklı kişi bu kılavuzu tamamladı.

Yazar

5 tane daha katılımcı ile

Jessica Chaidez

Üyelik tarihi: 01/13/10

8.013 İtibar

3 adet Kılavuz yazıldı

Rozetler: 15

+12 tane daha rozet

Ekip

Cal Poly, Team 5-8, Forte Winter 2010 Cal Poly, Team 5-8, Forte Winter 2010 üyesi

CPSU-FORTE-W10S5G8

7 Üyeler

20 adet Kılavuz yazıldı

2Kılavuz Yorumları

Is it possible to use an IDE to SATA connector? I want to install my Pioneer BDR burner to potentially use the PMG5 for data disc burning only. Any thoughts?

nirv - Yanıt

Misleading title. I know how to unplug the drive, thank you very much.

I've replaced the original drive with a better one and the %#*@ tray is stuck because it's too high.

engineer2137 - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 2

Son 7 gün: 12

Son 30 gün: 47

Her zaman: 35,182