Eşyalarını Tamir Et Topluluk Mağaza

PowerA Spectra Controller Buttons Replacement

Giriş

After frequent use of the controller, the buttons may get worn out and possibly get stuck depending on how long the controller has been used. Because of this frequent repetitive use, the buttons may need to be replaced.

Neye ihtiyacın var

  1. PowerA Spectra Controller Buttons Replacement, Rear Case: adım 1, 1 resimden 1.

    • Flip the controller over so the backplate is facing up.

    Düzenle

  2. PowerA Spectra Controller Buttons Replacement: adım 2, 1 resimden 1.

    • Use a Phillips #2 screwdriver to remove the eight 7.8 mm screws that secure the rear case.

    Düzenle

  4. PowerA Spectra Controller Buttons Replacement: adım 3, 1 resimden 1.

    • Hold the front case in one hand and pull the rear case off.

    Düzenle

  5. PowerA Spectra Controller Buttons Replacement, Buttons: adım 4, 1 resimden 1.

    • Use a Phillips screwdriver to remove the two 7.8 mm screws securing the motherboard to the chassis.

    Düzenle

  6. PowerA Spectra Controller Buttons Replacement: adım 5, 1 resimden 1.

    • Pull the motherboard away from the controller to access the buttons.

    • The motherboard is not fully removable because it is attached to the D-Pad. Be careful not to rip the motherboard from the D-Pad.

    Düzenle

  7. PowerA Spectra Controller Buttons Replacement: adım 6, 1 resimden 1.

    • Pull the old buttons out of the shell of the controller using the angled tweezers.

    Düzenle
Sonuç

To reassemble your device, follow the above steps in reverse order.
Repair didn’t go as planned? Try some basic troubleshooting or ask our Answers community for help.

0Kılavuz Yorumları

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 1

Son 30 gün: 6

Her zaman: 143