Ana içeriğe geç

Giriş

Install an original Airport 802.11b card internally.

Parçalar

    • Turn the G4 over.

    • Remove the eight Phillips screws from the lower case.

  1. Using your thumbs, slide the lower case away from you.
    • Using your thumbs, slide the lower case away from you.

    • The lower case may stick in the front on a tab just above the center of the DVD drive. Be careful as you work the case off, or you may break the thin strip of plastic just above the drive.

    • Lift the lower case off.

  2. iPhone Pil Tamir Setleri

    Only $29.99

    Buy Now

    iPhone Pil Tamir Setleri

    Only $29.99

    Buy Now
  3. Your laptop should look approximately like this.
    • Your laptop should look approximately like this.

  4. Skip this step if your computer does not have an Airport card.
    • Skip this step if your computer does not have an Airport card.

    • Firmly grasp the plastic tab attached to the Airport card and pull up and to the left.

    • Disconnect the antenna cable from the left side of the Airport card.

Sonuç

To reassemble your device, follow these instructions in reverse order.

2 farklı kişi bu kılavuzu tamamladı.

Ekli Belgeler

iRobot

Üyelik tarihi: 24-09-2009

1 İtibar

624 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 Gün: 1

Son 30 Gün: 9

Her zaman: 12,580