Eşyalarını Tamir Et Topluluk Mağaza

PowerLead Puto PLD003 Back Buttons Replacement

Giriş

This guide shows how to remove the screws that hold the camera together, how to remove the side panel from the camera, how to remove the back panel, and how to replace the back buttons.

Neye ihtiyacın var

  1. PowerLead Puto PLD003 Back Buttons Replacement, Side Panel: adım 1, 1 resimden 1.

    • Slide the battery eject button open to release the battery door.

    Düzenle

  2. PowerLead Puto PLD003 Back Buttons Replacement: adım 2, 1 resimden 1.

    • With the battery door open, carefully remove all four 5 mm Phillips #1 screws.

    Düzenle

  3. PowerLead Puto PLD003 Back Buttons Replacement: adım 3, 1 resimden 1.

    • Rotate the camera so that the underside is facing up.

    • Remove the four 5 mm Phillips #1 screws.

    Düzenle

  5. PowerLead Puto PLD003 Back Buttons Replacement: adım 4, 1 resimden 1.

    • Place the camera on a flat surface, with its underside facing you.

    • Gently pull up on the side panel to remove it from the camera.

    Düzenle

  6. PowerLead Puto PLD003 Back Buttons Replacement, Back Buttons: adım 5, 2 resimden 1. PowerLead Puto PLD003 Back Buttons Replacement, Back Buttons: adım 5, 2 resimden 2.

    • Remove the three 4 mm Phillips #1 screws holding the weight.

    • Remove the weight.

    Düzenle

  7. PowerLead Puto PLD003 Back Buttons Replacement: adım 6, 1 resimden 1.

    • Remove the two 4 mm Phillips #1 screws holding the back panel in place.

    Düzenle

  8. PowerLead Puto PLD003 Back Buttons Replacement: adım 7, 1 resimden 1.

    • Apply pressure to the back panel, away from the camera to remove.

    Düzenle

  9. PowerLead Puto PLD003 Back Buttons Replacement: adım 8, 2 resimden 1. PowerLead Puto PLD003 Back Buttons Replacement: adım 8, 2 resimden 2.

    • Place the back panel so the buttons are facing down and the circuit board is facing up.

    • Remove the three 4 mm Phillips #1 screws holding the circuit board in place.

    Düzenle

  10. PowerLead Puto PLD003 Back Buttons Replacement: adım 9, 1 resimden 1.

    • Set aside the circuit board.

    • These nubs are what is currently holding the buttons in place.

    • Carefully apply pressure and remove the set of buttons from the nubs.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 1

Her zaman: 145