Ana içeriğe geç

Giriş

Is your drone controller not lighting up? A possible cause could be dead batteries. Follow these steps to learn how to replace the batteries. No tools are required because the screwdriver in included in the remote control.

  1. On the right side of the controller, slide the small screw driver out.
    • On the right side of the controller, slide the small screw driver out.

  2. Flip the controller over, so the black panels are facing up.
    • Flip the controller over, so the black panels are facing up.

  3. iPhone Pil Tamir Setleri

    Only $29.99

    Buy Now

    iPhone Pil Tamir Setleri

    Only $29.99

    Buy Now
  4. Unscrew the small screw on the left bottom side. The screw should be on the plastic piece that has an upwards facing arrow. Repeat for the screw on the bottom right hand side.
    • Unscrew the small screw on the left bottom side. The screw should be on the plastic piece that has an upwards facing arrow.

    • Repeat for the screw on the bottom right hand side.

  5. Pull the plastic piece off to reveal the compartment where the batteries go.
    • Pull the plastic piece off to reveal the compartment where the batteries go.

  6. Remove the old batteries.
    • Remove the old batteries.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Miranda Brinkley

Üyelik tarihi: 22-10-2018

413 İtibar

3 adet Kılavuz yazıldı

Takım

UC Davis, Team S11-G5, Lore Fall 2018 UC Davis, Team S11-G5, Lore Fall 2018 üyesi

UCD-LORE-F18S11G5

3 Üyeler

4 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 3

Son 30 Gün: 15

Her zaman: 203