Eşyalarını Tamir Et Topluluk Mağaza

Protocol Dronium One Landing Gear Replacement

Giriş

This guide will walk you through the simple steps to replace the landing gears to help your drone land and fly properly.

Neye ihtiyacın var

  1. Protocol Dronium One Landing Gear Replacement, Landing Gear: adım 1, 2 resimden 1. Protocol Dronium One Landing Gear Replacement, Landing Gear: adım 1, 2 resimden 2.

    • Remove the eight 5.2mm screws located on the drone base using a Phillips 00 screwdriver with a thin end.

    Düzenle

  2. Protocol Dronium One Landing Gear Replacement: adım 2, 1 resimden 1.

    • Once all of the screws are off, lift off the top of the drone.

    Düzenle

  4. Protocol Dronium One Landing Gear Replacement: adım 3, 2 resimden 1. Protocol Dronium One Landing Gear Replacement: adım 3, 2 resimden 2.

    • Remove the two 5.2mm screws holding the landing gear in place using a Phillips 00 screwdriver and an extension if needed.

    Düzenle

  5. Protocol Dronium One Landing Gear Replacement: adım 4, 1 resimden 1.

    • Once the inside screws are removed, carefully pull off the one of the landing gear legs. Repeat this step for the other leg.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

Yazar

4 tane daha katılımcı ile

Ameth Ramos

Üyelik tarihi: 02/20/17

537 İtibar

5 adet Kılavuz yazıldı

Rozetler: 10

+7 tane daha rozet

Ekip

USF Tampa, Team S2-G5, Sullivan Spring 2017 USF Tampa, Team S2-G5, Sullivan Spring 2017 üyesi

USFT-SULLIVAN-S17S2G5

4 Üyeler

5 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 gün: 3

Son 30 gün: 4

Her zaman: 434