Ana içeriğe geç

Giriş

In order to reach the rear speaker, the back of the tablet must be removed. This guide requires basic knowledge of soldering.

  1. Remove these four 4 mm Phillips #00 screws. Remove these four 4 mm Phillips #00 screws.
    • Remove these four 4 mm Phillips #00 screws.

  2. Run a spudger tool around the edge of the screen to loosen it and begin to pry upward. The screen will be able to be removed once you see it pop up like it has in the photo.
    • Run a spudger tool around the edge of the screen to loosen it and begin to pry upward.

    • The screen will be able to be removed once you see it pop up like it has in the photo.

    • There are wires attached to the back cover and screen so be careful not to pull them apart.

  3. With a soldering iron, remove the wires from the circuit board. Due to the size of the wires, tweezers may be necessary. Due to the size of the wires, tweezers may be necessary.
    • With a soldering iron, remove the wires from the circuit board.

    • Due to the size of the wires, tweezers may be necessary.

  4. Use a metal spudger to pry out the speakers from its housing.
    • Use a metal spudger to pry out the speakers from its housing.

Sonuç

To reassemble your device, follow these instructions in reverse order.

2 farklı kişi bu kılavuzu tamamladı.

Nicholas Alexander

Üyelik tarihi: 21-09-2016

312 İtibar

2 adet Kılavuz yazıldı

Takım

UC Davis, Team 1-2, Oliver Fall 2016 UC Davis, Team 1-2, Oliver Fall 2016 üyesi

UCD-OLIVER-F16S1G2

5 Üyeler

4 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 0

Her zaman: 284