RIDGID R32104 Trigger Replacement

Giriş

If the trigger in your Worm Drive Saw won’t respond when pressed or appears to be broken, use this guide to remove and replace your trigger switch and trigger. All you need are the standard Phillips 2 Screwdriver and Torque 20 Screwdriver, in order to remove the two types of screws involved with this replacement.

Neye ihtiyacın var

Adım 1 Trigger

RIDGID R32104 Trigger Replacement, Trigger: adım 1, 1 resimden 1.

Turn off your saw and unplug before starting.
Place the Worm Drive Saw down and adjust the base plate, so that way the main housing assembly and handle set is easily accessible.

Düzenle

Adım 2

Using the Torque 20 screwdriver, remove the twelve 3/10 cm screws holding the handle set together.

Düzenle

Adım 3

Carefully remove the handle set from the main housing assembly.

Düzenle

Adım 4

RIDGID R32104 Trigger Replacement: adım 4, 3 resimden 3.

Place the Worm Drive Saw on its side to help remove the trigger.
Use the Torque 20 screwdriver to remove the single 3/10 cm screw that attaches the trigger switch to the handle set.

Düzenle