Giriş

This guide will give a step by step walkthrough of how to replace an old seat cushion with a new one.

  1. Loosen the seat clamp by pulling the black lever away from the frame. Once this is done, simply rotate the lever counter-clockwise to loosen the seat.
    • Loosen the seat clamp by pulling the black lever away from the frame. Once this is done, simply rotate the lever counter-clockwise to loosen the seat.

    • Stand on the right side of the bike while loosening the lever and make sure the bike isn't upside-down. This will prevent the seat from falling off during this process.

    Yorum Ekle

  2. Now that the seat is loosened, slowly pull up on the seat cushion until it is fully out of the frame. Next, place the seat on the ground.
    • Now that the seat is loosened, slowly pull up on the seat cushion until it is fully out of the frame. Next, place the seat on the ground.

    Yorum Ekle

    • Use an Allen wrench to unscrew the bolt that is holding the post to the seat cushion.

    Yorum Ekle

    • Now that the bolt is loosened, carefully pull the seat cushion from the post. Next remove the two riders as shown in the second image.

    Yorum Ekle

Sonuç

Now you are ready to reassemble the seat with your new cushion. Just follow these same steps in the reverse order. Thanks for taking the time to use this guide!

Bir başkası bu kılavuzu tamamladı.

Dante Bozzini

Üyelik tarihi: 26-09-2012

35 İtibar

1 Kılavuz yazıldı

Takım

Cal Poly, Team 7-49, Forte Fall 2012 Cal Poly, Team 7-49, Forte Fall 2012 üyesi

CPSU-FORTE-F12S7G49

5 Üyeler

5 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 31

Her zaman: 1,501