Giriş

This guide will give a step by step procedure of how to remove and replace the front and back covers of the Canon PowerShot A550.

Unscrew  a total of 6 4.45 mm phillips head screws using a #00 phillips head screwdriver. There are 2 screws on the left side (when looking at the front of the camera). There are 3 screws on the bottom
  • Unscrew a total of 6 4.45 mm phillips head screws using a #00 phillips head screwdriver.

  • There are 2 screws on the left side (when looking at the front of the camera).

  • There are 3 screws on the bottom

  • There is 1 screw on the right side

Yorum Ekle

Turn to the bottom of the camera.
  • Turn to the bottom of the camera.

  • Open the memory card cover by sliding the "CARD/BATT." button up, and then pulling the cover to the left.

Yorum Ekle

This is what the SD card/battery compartment looks like when opened.
  • This is what the SD card/battery compartment looks like when opened.

  • Remove one 4.45mm phillips head screw from the SD card/battery compartment using a #00 phillips head screwdriver.

Yorum Ekle

Gently remove the front cover away from the camera body. Tip: Start by loosening the teeth on the left side of the camera next to the battery compartment.
  • Gently remove the front cover away from the camera body.

  • Tip: Start by loosening the teeth on the left side of the camera next to the battery compartment.

Yorum Ekle

The camera should look like this once the front cover is removed.
  • The camera should look like this once the front cover is removed.

Yorum Ekle

Start from the battery compartment and remove the back cover. Caution: Do not tug on the back cover after it is removed. This could tear the ribbon attaching the back cover to the camera body. Remove the connecting ribbon from the body of the camera using a pair of tweezers.
  • Start from the battery compartment and remove the back cover.

  • Caution: Do not tug on the back cover after it is removed. This could tear the ribbon attaching the back cover to the camera body.

  • Remove the connecting ribbon from the body of the camera using a pair of tweezers.

Yorum Ekle

Once the ribbon connecting the back cover is removed, the back of the camera body should look like this.
  • Once the ribbon connecting the back cover is removed, the back of the camera body should look like this.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

2 başka kişi bu kılavuzu tamamladı.

Shaelyn Thomas

Üyelik tarihi: 19-04-2011

287 İtibar

4 adet Kılavuz yazıldı

Takım

Cal Poly, Team 8-6, Regan Spring 2011 Cal Poly, Team 8-6, Regan Spring 2011 üyesi

CPSU-REGAN-S11S8G6

4 Üyeler

8 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 2

Son 30 Gün: 6

Her zaman: 3,358