Parçalar

Hiçbir parçaya gerek yok.

Eject the disk tray from the DVD player before removing power supply.
  • Eject the disk tray from the DVD player before removing power supply.

Yorum Ekle

Evenly lift upward on the disk tray front cover (not slanted, as pictured). This will allow for easier dissasembly of the player.
  • Evenly lift upward on the disk tray front cover (not slanted, as pictured). This will allow for easier dissasembly of the player.

Yorum Ekle

Remove 3 screws running along back edge of case cover. Remove 2 screws from each side of case cover.
  • Remove 3 screws running along back edge of case cover.

  • Remove 2 screws from each side of case cover.

Yorum Ekle

Grab edges of cover, pull outward slightly, and pull straight up.
  • Grab edges of cover, pull outward slightly, and pull straight up.

Yorum Ekle

Lift up the 5 tabs securing the front panel to the chassis. There are 3 on the bottom, and 2 on the inside edges of the panel. Panel should then lift off the player. Lift up the 5 tabs securing the front panel to the chassis. There are 3 on the bottom, and 2 on the inside edges of the panel. Panel should then lift off the player.
  • Lift up the 5 tabs securing the front panel to the chassis. There are 3 on the bottom, and 2 on the inside edges of the panel. Panel should then lift off the player.

Yorum Ekle

Remove the blue ribbon wire from its connector. When doing this, be cautious to not damage the connector. Place forefinger under cable loop as shown, gripping with thumb.
  • Remove the blue ribbon wire from its connector. When doing this, be cautious to not damage the connector.

  • Place forefinger under cable loop as shown, gripping with thumb.

  • Pull straight up. It should disconnect with little force.

Yorum Ekle

Using tweezers or pliers, squeeze the tabs of the plastic fasteners together. While doing this, gently lift up on the motherboard until the fasteners are released. Using tweezers or pliers, squeeze the tabs of the plastic fasteners together. While doing this, gently lift up on the motherboard until the fasteners are released.
  • Using tweezers or pliers, squeeze the tabs of the plastic fasteners together. While doing this, gently lift up on the motherboard until the fasteners are released.

Yorum Ekle

Remove the two screws securing the motherboard using a philips screw driver.
  • Remove the two screws securing the motherboard using a philips screw driver.

Yorum Ekle

Lift the board from the side closest to the front panel (top of photo).
  • Lift the board from the side closest to the front panel (top of photo).

  • Gently apply force until bottom connector releases from power board below.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

Kevin

Üyelik tarihi: 26-04-2011

351 İtibar

8 adet Kılavuz yazıldı

Takım

Cal Poly, Team 18-20, Garner Spring 2011 Cal Poly, Team 18-20, Garner Spring 2011 üyesi

CPSU-GARNER-S11S18G20

4 Üyeler

11 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 Gün: 3

Son 30 Gün: 10

Tüm Zamanlar: 2,561