Giriş

This guide will show how to replace the speaker on the Casio camera

Parçalar

Hiçbir parçaya gerek yok.

Remove the four screws on the side with the speaker
  • Remove the four screws on the side with the speaker

Yorum Ekle

Remove the four screws from the bottom of the camera.
  • Remove the four screws from the bottom of the camera.

  • Note: Bottom screws are longer than the top ones, so label accordingly for easy reassembly

Yorum Ekle

Remove the four screws on the side opposite of the speaker.
  • Remove the four screws on the side opposite of the speaker.

Yorum Ekle

Pull apart the bottom casing.
  • Pull apart the bottom casing.

Yorum Ekle

Remove ribbon from the rear casing. Set aside rear casing.
  • Remove ribbon from the rear casing.

  • Set aside rear casing.

Yorum Ekle

Use tweezers or prongs to pry the LCD screen off from the opening. Note: The bottom of the LCD screen is attached to the frame by a few pieces of black tape.
  • Use tweezers or prongs to pry the LCD screen off from the opening.

  • Note: The bottom of the LCD screen is attached to the frame by a few pieces of black tape.

Yorum Ekle

Lift up the LCD screen, slowly move it to the other side. Lift up the LCD screen, slowly move it to the other side.
  • Lift up the LCD screen, slowly move it to the other side.

Yorum Ekle

Pry off the LCD casing which is taped on to the frame. Pry off the LCD casing which is taped on to the frame.
  • Pry off the LCD casing which is taped on to the frame.

Yorum Ekle

Flip open the connector holding the ribbon. Pull out the LCD screen with the ribbon from the camera. Pull out the LCD screen with the ribbon from the camera.
  • Flip open the connector holding the ribbon.

  • Pull out the LCD screen with the ribbon from the camera.

Yorum Ekle

Pull apart the front casing. Pull apart the front casing.
  • Pull apart the front casing.

Yorum Ekle

Remove two screws on the side where the battery is located. Remove the lanyard loop after the screws come off.
  • Remove two screws on the side where the battery is located.

  • Remove the lanyard loop after the screws come off.

  • Slowly pull the side casing so it becomes dislocated from the top of the camera frame.

Yorum Ekle

On the front of the camera near the flash flip the connector holding the ribbon. Remove the ribbon from the connector.
  • On the front of the camera near the flash flip the connector holding the ribbon.

  • Remove the ribbon from the connector.

Yorum Ekle

Carefully remove the L shaped frame from the camera At the bottom of the camera the L shaped frame is being held in by two plastic bumps and a metal tab. Pop the frame off the bumps and tabs.
  • Carefully remove the L shaped frame from the camera

  • At the bottom of the camera the L shaped frame is being held in by two plastic bumps and a metal tab.

  • Pop the frame off the bumps and tabs.

  • Note: There is a yellow and orange wire soldered onto the camera. Be careful not to pull them off.

  • The blue box is the speaker

Yorum Ekle

Remove the speaker with tweezers
  • Remove the speaker with tweezers

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Christian

Üyelik tarihi: 28-01-2011

320 İtibar

3 adet Kılavuz yazıldı

Takım

Cal Poly, Team 4-38, Regan Winter 2011 Cal Poly, Team 4-38, Regan Winter 2011 üyesi

CPSU-REGAN-W11S4G38

4 Üyeler

7 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 0

Her zaman: 2,511