Giriş

This is a step by step guide to removing the keyboard cover of an IBM ThinkPad 560z. The keyboard cover is most commonly removed to facilitate the cleaning or replacement of the keyboard.

  1. Remove the 7 mm Philip screws.
    • Remove the 7 mm Philip screws.

    • Remove the 10 mm Philip screws.

    • Remove the 14 mm Philip screw.

    Yorum Ekle

  2. Open the flap on the left hand side.
    • Open the flap on the left hand side.

    Yorum Ekle

    • Insert the iPod opening tools between the right and left sides of the latch.

    • Pry the right side of the latch, and then pry the left side to detach the laptop's cover.

    Yorum Ekle

    • Open the flap on the right side.

    Yorum Ekle

    • Insert the iPod opening tools towards the right side of the latch.

    • Gently pry the right side out to release the top cover.

    Yorum Ekle

    • Lift the keyboard slowly.

    • A cable connects the keyboard to the motherboard. If you are not careful, you will damage the cable.

    Yorum Ekle

    • Use your fingers or a spudger to detach the connector.

    Yorum Ekle

    • Carefully lift and remove the keyboard.

    Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Derek Driscoll

Üyelik tarihi: 15-04-2010

119 İtibar

8 adet Kılavuz yazıldı

Takım

Cal Poly, Team 26-27, Regan Spring 2010 Cal Poly, Team 26-27, Regan Spring 2010 üyesi

CPSU-REGAN-S10S26G27

3 Üyeler

18 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 0

Her zaman: 1,498