Eşyalarını Tamir Et Topluluk Mağaza

Replacing Motorola Photon Q 4G LTE Front Glass Digitizer

Neye ihtiyacın var

  1. Replacing Motorola Photon Q 4G LTE Front Glass Digitizer, Front Glass Digitizer: adım 1, 2 resimden 1. Replacing Motorola Photon Q 4G LTE Front Glass Digitizer, Front Glass Digitizer: adım 1, 2 resimden 2.

    • Use the pry tool around edges of case where keyboard is located to take the back cover off. Be careful not to break the cover where the SD card slot is; the cover is very thin and fragile in that area. (I broke mine.)

    Düzenle

  2. Replacing Motorola Photon Q 4G LTE Front Glass Digitizer: adım 2, 3 resimden 1. Replacing Motorola Photon Q 4G LTE Front Glass Digitizer: adım 2, 3 resimden 2. Replacing Motorola Photon Q 4G LTE Front Glass Digitizer: adım 2, 3 resimden 3.

    • Remove the black screws around the outer edges and the 4 silver screws. (You'll find a silver screw on each side of the vibrator motor and on each side of the rear camera.)

    Düzenle

  3. Replacing Motorola Photon Q 4G LTE Front Glass Digitizer: adım 3, 1 resimden 1.

    • Now remove the circuit board's protective cover (the one you just unscrewed) by lifting it gently from the top. Three tabs need to be unclipped using the pry tool. Unclip at least 2 of the 3 clips and final tab should loosen on its own.

    Düzenle

  4. Replacing Motorola Photon Q 4G LTE Front Glass Digitizer: adım 4, 1 resimden 1.

    • Now remove the 2 big silver screws in the battery ribbon cable that is attached to the circut board...

    Düzenle

    • take pry tool and slide underneath the battery very very gently being careful not to damage the components underneath and gently lift up until the battery comes loose..Adhesive is whats under battery holding it scurely to circut board. ?

    Düzenle

  7. Replacing Motorola Photon Q 4G LTE Front Glass Digitizer: adım 6, 1 resimden 1.

    • remove the one silver screw in the center of the circuit board which is holding it down

    Düzenle

    • now remove the keyboard from the front LCD screen by slowly lifting the two apart and and remove snap on ribbon cables that are holding it LCD screen to keyboard

    Düzenle

  9. Replacing Motorola Photon Q 4G LTE Front Glass Digitizer: adım 8, 1 resimden 1.

    • Remove the 7 screws ont the outer edge of the back lcd display

    Düzenle

  10. Replacing Motorola Photon Q 4G LTE Front Glass Digitizer: adım 9, 1 resimden 1.

    • remove the back plate to the LCD screen being careful not to tear the ribbon cables and slide them through the slot.. then set it aside

    Düzenle

  11. Replacing Motorola Photon Q 4G LTE Front Glass Digitizer: adım 10, 1 resimden 1.

    • remove the 3 screws that hold the top circuit board to the phone

    Düzenle

  12. Replacing Motorola Photon Q 4G LTE Front Glass Digitizer: adım 11, 1 resimden 1.

    • remove the rubber on the back of digitizer and transfer it over to the new digitizer make sure to use a heat gun to eat the adhesive on the backside of rubber to get off easily

    Düzenle

  13. Replacing Motorola Photon Q 4G LTE Front Glass Digitizer: adım 12, 1 resimden 1.

    • slowly pulled the speaker away from digitizer and transfer that over to your new digitizer is well.. be careful not to break your speaker I broke mine mine came apart and now it doesn't work at is my phone in speaker phone keep that in mind

    Düzenle

  14. Replacing Motorola Photon Q 4G LTE Front Glass Digitizer, Attatching new digitizer: adım 13, 3 resimden 1. Replacing Motorola Photon Q 4G LTE Front Glass Digitizer, Attatching new digitizer: adım 13, 3 resimden 2. Replacing Motorola Photon Q 4G LTE Front Glass Digitizer, Attatching new digitizer: adım 13, 3 resimden 3.

    • now get your new digitizer and take the plastic protective covering of it and put your rubber adhesive on new digitizer screen and put digitizer on phone and slide the ribbon cable through the slot provided and a attach ribbon cable to circut board

    Düzenle

  15. Replacing Motorola Photon Q 4G LTE Front Glass Digitizer: adım 14, 1 resimden 1.

    • reverse all the steps to put your phone back together and then you have a new phone

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

7 farklı kişi bu kılavuzu tamamladı.

Yazar

5 tane daha katılımcı ile

Braden Woods

Üyelik tarihi: 04/05/14

295 İtibar

1 Kılavuz yazıldı

Rozetler: 5

+2 tane daha rozet

Ekip

Apple Service Centre Apple Service Centre üyesi

Community

36 Üyeler

25 adet Kılavuz yazıldı

0Kılavuz Yorumları

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 7

Son 30 gün: 50

Her zaman: 6,025