Ana içeriğe geç

Giriş

The PODZ port is located on the back face of the Ion Air Pro. This port allows the WI-Fi PODZ Pack accessory to be installed.

Parçalar

Hiçbir parça belirtilmedi.

  1. Remove the 6 screws securing the lens cover bezel using a #00 Phillips screwdriver. This will allow you to remove the bezel and lens cover. Remove the 6 screws securing the lens cover bezel using a #00 Phillips screwdriver. This will allow you to remove the bezel and lens cover. Remove the 6 screws securing the lens cover bezel using a #00 Phillips screwdriver. This will allow you to remove the bezel and lens cover.
    • Remove the 6 screws securing the lens cover bezel using a #00 Phillips screwdriver. This will allow you to remove the bezel and lens cover.

  2. Remove the metal camera body cover by sliding it toward the lens end of the camera.
    • Remove the metal camera body cover by sliding it toward the lens end of the camera.

  3. Remove 2 screws on the bottom of the camera body using a #00 Phillips screwdriver.
    • Remove 2 screws on the bottom of the camera body using a #00 Phillips screwdriver.

  4. iPhone Pil Tamir Setleri

    Only $29.99

    Buy Now

    iPhone Pil Tamir Setleri

    Only $29.99

    Buy Now
  5. Remove the 3 screws that secure the camera to the body using a #00 Phillips screwdriver.
    • Remove the 3 screws that secure the camera to the body using a #00 Phillips screwdriver.

  6. Use a plastic pry tool to remove the plastic ring covering the rear screws.
    • Use a plastic pry tool to remove the plastic ring covering the rear screws.

  7. Remove the 8 screws around the perimeter of the back cover. Remove the 2 screws in the PODZ port.
    • Remove the 8 screws around the perimeter of the back cover.

    • Remove the 2 screws in the PODZ port.

  8. Slide PODZ port out of the camera body.
    • Slide PODZ port out of the camera body.

    • Disconnect ribbon cable from the back of the PODZ port.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Christopher Brandl

Üyelik tarihi: 09-10-2018

670 İtibar

5 adet Kılavuz yazıldı

Takım

UW Stout, Team S6-G2, Ogden Fall 2018 UW Stout, Team S6-G2, Ogden Fall 2018 üyesi

UWSTOUT-OGDEN-F18S6G2

4 Üyeler

5 adet Kılavuz yazıldı

Bir Yorum

How do you reconnect the ribbon cable to the back of the PODZ port when you reassemble?

Peter Niepel - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 3

Son 30 Gün: 10

Her zaman: 105