Ana içeriğe geç

Giriş

It doesn’t happen often, but when a wheel on your Patagonia Wheeled Luggage blows out, it can leave you stopped in your tracks. Fortunately, installing a replacement wheel is quick and only requires a single hex screwdriver.

For replacement parts or further assistance, contact Patagonia Customer Service.

Aletler

Parçalar

Hiçbir parça belirtilmedi.

  1. Lay the bag down, with the problem wheel facing you.
    • Lay the bag down, with the problem wheel facing you.

    • Zipping the bag closed will keep it from flopping about as you work.

  2. iPhone Pil Tamir Setleri

    Only $29.99

    Buy Now

    iPhone Pil Tamir Setleri

    Only $29.99

    Buy Now
  3. Using a hex 4.0 screwdriver, remove the threaded bolt in the center of of the wheel. This is the screw closest to the ground when the bag is upright. Remove the bolt by pulling it straight out of the hole. Remove the bolt by pulling it straight out of the hole.
    • Using a hex 4.0 screwdriver, remove the threaded bolt in the center of of the wheel. This is the screw closest to the ground when the bag is upright.

    • Remove the bolt by pulling it straight out of the hole.

  4. Using one hand to lift and support the bag, take the wheel in your other hand. Pull the wheel out of its casing. Removing the wheel may take a little force, do not be afraid to give it a tug.
    • Using one hand to lift and support the bag, take the wheel in your other hand. Pull the wheel out of its casing.

    • Removing the wheel may take a little force, do not be afraid to give it a tug.

    • To install your replacement wheel, follow these steps in reverse order with your new wheel.

Bitiş Çizgisi

4 farklı kişi bu kılavuzu tamamladı.

Brittany McCrigler

Üyelik tarihi: 05-03-2012

81.671 İtibar

132 adet Kılavuz yazıldı

Takım

iFixit iFixit üyesi

Community

101 Üyeler

8.734 adet Kılavuz yazıldı

Bir Yorum

What do you do when the nut inside the wheel housing comes loose? I can hear it rolling around in the housing. The bolt has nothing to screw back into. Is there any way to take the housing off? It looks to be held on by rivets. I'm guessing that's not a good sign.

Derek Emanuel - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 4

Son 7 Gün: 23

Son 30 Gün: 101

Her zaman: 4,423