Giriş

This repair guide will give you step by step instructions on how to remove the Macintosh PowerBook 1400c Monitor.

Turn the device upside down and then locate the battery latch near the front of the device.
  • Turn the device upside down and then locate the battery latch near the front of the device.

Yorum Ekle

Slide the latch to the left to release the battery.
  • Slide the latch to the left to release the battery.

Yorum Ekle

  • Continue holding the latch then gently pull the battery out of the device.

  • Place the battery in a safe location.

Yorum Ekle

  • Locate the CD-ROM Drive latch.

Yorum Ekle

  • Slide the latch to the right to release the CD ROM drive.

Yorum Ekle

  • Continue holding the latch then gently pull the CD-ROM Drive out of the device.

  • Place the CD ROM drive in a safe location.

Yorum Ekle

  • Locate the speaker cover.

Yorum Ekle

  • Press firmly on each end of the speaker cover and slide it to the left.

I found it was easy to get a spudger over the left edge and lift it up a bit, then push the bar to the left, It pops right off after that.

Jimmy James - Yanıt

  • Gently lift the speaker cover to remove it.

Yorum Ekle

  • Lift the keyboard up from the back using a spudger(wedge side).

Yorum Ekle

  • Gently lift the keyboard until only the ribbon cable remains attached.

Yorum Ekle

  • Tilt the keyboard away from the screen.

Yorum Ekle

  • Locate the six screws that secure the heatsink.

This is not necessary to remove the HDD. Go directly to step 20.

Kenneth DeVries - Yanıt

That isn't the HDD!

Dix Dox - Yanıt

  • Remove the six screws from the heatsink using the Philips #1 screwdriver.

Yorum Ekle

  • Lift the heatsink from the side closest to the laptop screen.

Yorum Ekle

  • Remove the heatsink.

Yorum Ekle

  • Gently pull up on the beige ribbon lock until it moves a short distance on both sides to separate the ribbon cable from the connector.

Yorum Ekle

  • Detach the ribbon cable.

Yorum Ekle

  • Remove the keyboard.

Yorum Ekle

  • Identify the right and left monitor end caps.

Yorum Ekle

  • Pry off the end caps by putting a spudger between the monitor hinge and the end cap and prying outwards.

Yorum Ekle

  • Once the end cap has been loosened by the spudger, pull outwards on the end caps.

Yorum Ekle

  • Completely remove both end caps.

Yorum Ekle

  • Identify the 4 total screw under the end caps (2 under each end cap).

    • The two outside 16mm long screws

    • The two inside 5.4mm long screws

Yorum Ekle

  • Lay the monitor all the way back.

Yorum Ekle

  • Remove the 4 screws using the Phillips #0 screwdriver.

Yorum Ekle

  • Identify the center cap of the monitor.

Yorum Ekle

  • Pry the center cap off by placing the spudger between the hinge and the center cap and prying upwards.

Yorum Ekle

  • Detach the center cap completely.

Yorum Ekle

  • Identify the one 12.6mm long screw under the center cap.

Yorum Ekle

  • Remove the center screw with a Phillips #0 screwdriver.

Yorum Ekle

  • Lift upwards on the metal cover under the screw.

Yorum Ekle

  • Completely remove the metal cover.

Yorum Ekle

  • Identify where the left and right monitor cords are attached to the logic board

    • The base of the left monitor cord

    • The base of the right monitor cord

Yorum Ekle

  • To detach the left monitor cord grab the left monitor cord at the base of the cord and pull vertically up.

Yorum Ekle

  • Completely detach the left monitor cord from the logic board.

Yorum Ekle

  • To detach the right monitor cord grab the right monitor cord at the base of the cord and pull vertically up.

Yorum Ekle

  • Completely detach the right monitor cord from the logic board.

Yorum Ekle

  • Completely remove the monitor from the computer.

Yorum Ekle

Sonuç

Once the monitor has been removed, to attach the new monitor follow these instructions in reverse order.

2 başka kişi bu kılavuzu tamamladı.

Taylor Chris

Üyelik tarihi: 01-04-2011

85 İtibar

1 Kılavuz yazıldı

Takım

Cal Poly, Team 10-39, Forte Spring 2011 Cal Poly, Team 10-39, Forte Spring 2011 üyesi

CPSU-FORTE-S11S10G39

5 Üyeler

6 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 Gün: 1

Son 30 Gün: 9

Her zaman: 2,507