Eşyalarını Tamir Et Topluluğa Katılın Mağaza

Ryobi RJ1861V Saw Bar Assembly Replacement

Giriş

This guide demonstrates how to remove and replace the saw bar assembly in a Ryobi RJ1861V reciprocating saw.

Neye ihtiyacın var

  1. Ryobi RJ1861V Saw Bar Assembly Replacement, Saw Bar Assembly: adım 1, 1 resimden 1.

    • Use a Torx T5 screwdriver to remove the single 8 mm screw securing the shoe.

    Düzenle

  2. Ryobi RJ1861V Saw Bar Assembly Replacement: adım 2, 2 resimden 1. Ryobi RJ1861V Saw Bar Assembly Replacement: adım 2, 2 resimden 2.

    • Remove the rubber sleeve.

    • You may have to use some force as it has a tight fit.

    Düzenle

  3. Ryobi RJ1861V Saw Bar Assembly Replacement: adım 3, 1 resimden 1.

    • Use a Torx T5 screwdriver to remove the six screws on the underside of the device.

    Düzenle

  5. Ryobi RJ1861V Saw Bar Assembly Replacement: adım 4, 1 resimden 1.

    • Use a Torx T5 screwdriver to remove the four screws on the top.

    • There are two screws on each side of the device.

    Düzenle

  6. Ryobi RJ1861V Saw Bar Assembly Replacement: adım 5, 1 resimden 1.

    • Remove the backside panel.

    Düzenle

  7. Ryobi RJ1861V Saw Bar Assembly Replacement: adım 6, 1 resimden 1.

    • Unscrew the four T5 Torx screws that are holding the assembly bar in place.

    Düzenle

  8. Ryobi RJ1861V Saw Bar Assembly Replacement: adım 7, 1 resimden 1.

    • Lift the assembly bar up and out of the chassis.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 2

Son 30 gün: 15

Her zaman: 779