Ana içeriğe geç

Bu kılavuzda güncel değişiklikler var. En son onaylanmamış sürüme geçin.

Ryobi RJ1861V Saw Bar Assembly Replacement

Neye ihtiyacın var

  1. Ryobi RJ1861V Saw Bar Assembly Replacement, Saw Bar Assembly: adım 1, 1 resimden 1.
    • Unscrew the screw holding the shoe in on the back side:

    • One 8 mm Torx T5 screw

  2. Ryobi RJ1861V Saw Bar Assembly Replacement: adım 2, 2 resimden 1. Ryobi RJ1861V Saw Bar Assembly Replacement: adım 2, 2 resimden 2.
    • Begin to remove rubber sleeve. You may have to use some force as it has a tight fit.

    • Indicated in the photo below is the rubber sleeve removed.

  3. Ryobi RJ1861V Saw Bar Assembly Replacement: adım 3, 1 resimden 1.
    • After sleeve is removed begin to remove the six screws on the back of the device.

    • Six Torx T5 Screws

  4. Ryobi RJ1861V Saw Bar Assembly Replacement: adım 4, 1 resimden 1.
    • Using a screw driver begin to unscrew the 4 screws on the top. There will be two screws on each side of the device.

    • Four Torx T5 Screws

  5. Ryobi RJ1861V Saw Bar Assembly Replacement: adım 5, 1 resimden 1.
    • Remove the backside panel to expose the internal components.

  6. Ryobi RJ1861V Saw Bar Assembly Replacement: adım 6, 1 resimden 1.
    • Unscrew the four T5 Torx screws that are holding the assembly bar in place.

  7. Ryobi RJ1861V Saw Bar Assembly Replacement: adım 7, 1 resimden 1.
    • After all screws removed, the assembly bar can be removed and replaced with ease.

Sonuç

To reassemble your device, follow these instructions in reverse order.

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 2

Son 30 gün: 18

Her zaman: 839