Ana içeriğe geç

Giriş

This guide will be showing step-by-step instructions on how to get to and replace the barrel of the airsoft gun.

Parçalar

Hiçbir parça belirtilmedi.

  1. Using a flathead screwdriver, remove the pin holding the hand guard in place. To remove this, turn the pin clockwise and push it through at the same time.
    • Using a flathead screwdriver, remove the pin holding the hand guard in place.

    • To remove this, turn the pin clockwise and push it through at the same time.

    • Pull the hand guard off.

  2. Using a Phillips #1 screwdriver, remove the two 8mm screws above the hand guard on both sides of the gun. There should be four total. Using a Phillips #1 screwdriver, remove the two 8mm screws above the hand guard on both sides of the gun. There should be four total.
    • Using a Phillips #1 screwdriver, remove the two 8mm screws above the hand guard on both sides of the gun. There should be four total.

  3. Locate the button to fold over the folding stock and fold over the folding stock. Using a Phillips #1 screwdriver, remove the 20mm screw located behind the folding stock.
    • Locate the button to fold over the folding stock and fold over the folding stock.

    • Using a Phillips #1 screwdriver, remove the 20mm screw located behind the folding stock.

  4. MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now

    MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now
  5. Turn the gun over so that you are facing the bottom of the gun. Using a Phillips #1 screwdriver, remove the following screws:
    • Turn the gun over so that you are facing the bottom of the gun.

    • Using a Phillips #1 screwdriver, remove the following screws:

    • Remove the 8mm screw located directly underneath the cocking lever.

    • Remove the 8mm screw beside the one you just removed.

  6. Carefully tug on the tip of the gun and pull the barrel and its cover out. Carefully tug on the tip of the gun and pull the barrel and its cover out.
    • Carefully tug on the tip of the gun and pull the barrel and its cover out.

  7. Pull the barrel out from the cover. Remove the pieces at the end of the barrel. Remove the pieces at the end of the barrel.
    • Pull the barrel out from the cover.

    • Remove the pieces at the end of the barrel.

  8. Remove the remaining pieces of on the ends of the barrel. Remove the remaining pieces of on the ends of the barrel.
    • Remove the remaining pieces of on the ends of the barrel.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Laura Schulz

Üyelik tarihi: 05-10-2012

1 İtibar

1 Kılavuz yazıldı

Takım

Cal Poly, Team 18-41, Regan Fall 2012 Cal Poly, Team 18-41, Regan Fall 2012 üyesi

CPSU-REGAN-F12S18G41

6 Üyeler

6 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 1

Son 30 Gün: 11

Her zaman: 1,195