Ana içeriğe geç

SOMNOcomfort and SOMNObalance Ventilator Filter Replacement

Tıbbi Ekipman
iFixit de, bu onarım kılavuzu da tıbbi cihaz üreticisi tarafından onaylanmış değildir ya da herhangi birinin üreticiyle alâkası yoktur.
  1. SOMNOcomfort and SOMNObalance Ventilator Filter Replacement, Filter: adım 1, 1 resimden 1.
    • Locate the Filter Compartment on the back of the ventilator.

  2. SOMNOcomfort and SOMNObalance Ventilator Filter Replacement: adım 2, 1 resimden 1.
    • Push the compartment cover (22) up (from the bottom)

  3. SOMNOcomfort and SOMNObalance Ventilator Filter Replacement: adım 3, 1 resimden 1.
    • Remove the coarse dust filter(68)

  4. SOMNOcomfort and SOMNObalance Ventilator Filter Replacement: adım 4, 1 resimden 1.
    • Remove the fine dust filter(67)

    • Replace the filters and close the cover on the rear of the unit.

  5. SOMNOcomfort and SOMNObalance Ventilator Filter Replacement: adım 6, 1 resimden 1.
    • Reset the filter change indicator by pressing and holding the on/off switch(19) until the filter change indicator goes blank.

    • If the fine filter was changed due to soiling before 250 operating hours, the hours meter must be reset to zero. Proceed as follows:

    • When switching the unit on, press and hold the on/off switch 19. The filter change indicator will come on after about three seconds before going off again after another three seconds. Release the on and off switch.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Diya Jamwal

Üyelik tarihi: 11/07/18

553 İtibar

3 adet Kılavuz yazıldı

Ekip

Cal Poly, Team S1-G3, Zimmerman Spring 2020 Cal Poly, Team S1-G3, Zimmerman Spring 2020 üyesi

CPSU-ZIMMERMAN-S20S1G3

5 Üyeler

10 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 0

Her zaman: 115