Ana içeriğe geç

Giriş

A guide on how to replace a damaged DC power board on a Samsung BD-7500.

  1. Remove the three 10mm screws with a Phillips #0 screwdriver.
    • Remove the three 10mm screws with a Phillips #0 screwdriver.

    • Pry the top off with a plastic opening tool.

  2. Remove the three screws holding down the cover with a Phillips #0 screwdriver.
    • Remove the three screws holding down the cover with a Phillips #0 screwdriver.

  3. Android Tamir Setleri

    Yeni bir ekran veya pil, bir tamir kiti kadar yakınında.

    Hemen Alışveriş Yapın

    Android Tamir Setleri

    Yeni bir ekran veya pil, bir tamir kiti kadar yakınında.

    Hemen Alışveriş Yapın
  4. Lift up the power cord at its base to remove it.
    • Lift up the power cord at its base to remove it.

  5. Insert a plastic opening tool into the black plastic tab on the cord and twist to separate.
    • Insert a plastic opening tool into the black plastic tab on the cord and twist to separate.

  6. Remove the 7mm screw with a Phillips #1 screwdriver.
    • Remove the 7mm screw with a Phillips #1 screwdriver.

    • Grip the blue tab attached to the base and pull upwards.

  7. Grip the edges of the motherboard and pull upwards to remove.
    • Grip the edges of the motherboard and pull upwards to remove.

Sonuç

To reassemble your device, follow these instructions in reverse order.

samer odeh

Üyelik tarihi: 13-02-2018

313 İtibar

1 Kılavuz yazıldı

Takım

USF Tampa, Team S16-G4, Boczar Spring 2018 USF Tampa, Team S16-G4, Boczar Spring 2018 üyesi

USFT-BOCZAR-S18S16G4

4 Üyeler

4 adet Kılavuz yazıldı

0 Comments

Yorum Ekle

İstatistikleri Görüntüle:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 10

Her zaman: 116