Ana içeriğe geç

Giriş

S5830, S5830i - how to disassemble and change / replace the loudspeaker, earpiece, main camera, LCD Display, Touch screen Digitizer Glass, etc.


Videoya Genel Bakış

  1. Switch off the phone. Remove the battery and any installed SIM and memory card.
    • Switch off the phone.

    • Remove the battery and any installed SIM and memory card.

  2. Remove the 7 Phillips screws. Use a plastic tool to remove the back cover. vibrating motor
    • Remove the 7 Phillips screws.

    • Use a plastic tool to remove the back cover.

    • vibrating motor

  3. Disconnect the earpiece & light sensor flex cable. Take off the Volume Up/Down buttons flex cable. Do the same with the Power button flex cable.
    • Disconnect the earpiece & light sensor flex cable.

    • Take off the Volume Up/Down buttons flex cable.

    • Do the same with the Power button flex cable.

    • Be careful don't brake the flex cables.

  4. Lift the microphone. Lift the board from the right side and disconnect the LCD display flex cable. Remove the board from the middle frame.
    • Lift the microphone.

    • Lift the board from the right side and disconnect the LCD display flex cable.

    • Remove the board from the middle frame.

  5. This is the main camera. This is the main camera.
    • This is the main camera.

  6. Android Tamir Setleri

    A new screen or battery is one kit away.

    Hemen Alışveriş Yapın

    Android Tamir Setleri

    A new screen or battery is one kit away.

    Hemen Alışveriş Yapın
  7. This is the loudspeaker & audio jack connector module. This is the loudspeaker & audio jack connector module. This is the loudspeaker & audio jack connector module.
    • This is the loudspeaker & audio jack connector module.

  8. Loudspeaker and light sensor module, Loudspeaker and light sensor module,
    • Loudspeaker and light sensor module,

  9. Disconnect the touch screen flex cable. Disconnect the touch screen flex cable.
    • Disconnect the touch screen flex cable.

  10. Use a hair dryer and warm the touch screen glass to make adhesive soften. Use a plastic tool for separating the glass from the middle frame. Use a plastic tool for separating the glass from the middle frame.
    • Use a hair dryer and warm the touch screen glass to make adhesive soften.

    • Use a plastic tool for separating the glass from the middle frame.

  11. Again by using a plastic tool, separate the LCD display from the middle frame. Again by using a plastic tool, separate the LCD display from the middle frame. Again by using a plastic tool, separate the LCD display from the middle frame.
    • Again by using a plastic tool, separate the LCD display from the middle frame.

  12. Clean the middle frame and install the LCD display. Clean the middle frame and install the LCD display. Clean the middle frame and install the LCD display.
    • Clean the middle frame and install the LCD display.

  13. Install the touch screen and start with reassembling. Install the touch screen and start with reassembling.
    • Install the touch screen and start with reassembling.

  14. That is all.
    • That is all.

    • .

    • .

    • .

    • .

    • Did you do it successfully?

Sonuç

To reassemble your device, follow these instructions in reverse order.

22 farklı kişi bu kılavuzu tamamladı.

ZFix

Üyelik tarihi: 09-12-2013

166.837 İtibar

305 adet Kılavuz yazıldı

Takım

Master Techs Master Techs üyesi

Community

290 Üyeler

822 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 6

Son 30 Gün: 31

Her zaman: 7,738