Ana içeriğe geç
  1. Insert a finger nail or plastic opening tool between the back cover and the device.
    • Insert a finger nail or plastic opening tool between the back cover and the device.

    • Gently pry the rear cover off of the back of the phone.

  2. Using a finger, pull the SIM card down out of its slot. Remove the SIM card.
    • Using a finger, pull the SIM card down out of its slot.

    • Remove the SIM card.

    • The pictured device is missing the SIM card and battery.

  3. Using a Phillips #00 screwdriver remove the eleven 3 mm screws.
    • Using a Phillips #00 screwdriver remove the eleven 3 mm screws.

  4. MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now

    MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now
  5. Insert a plastic opening tool between the screen and the back of the device. Starting at the bottom of the device, gently slide the tool along the edges of the screen. Gently pry the main assembly from the midframe of the device.
    • Insert a plastic opening tool between the screen and the back of the device.

    • Starting at the bottom of the device, gently slide the tool along the edges of the screen.

    • Gently pry the main assembly from the midframe of the device.

    • When removing the main assembly, pry gently so as to not crack the glass screen or break any clips within the device.

  6. Using the flat end of a spudger, disconnect the digitizer cable connector. Using the flat end of a spudger, disconnect the digitizer cable connector.
    • Using the flat end of a spudger, disconnect the digitizer cable connector.

  7. Using a plastic opening tool pry between silver digitizer and black back piece. Slowly slide plastic opening tool around the screen to loosen the adhesive.
    • Using a plastic opening tool pry between silver digitizer and black back piece.

    • Slowly slide plastic opening tool around the screen to loosen the adhesive.

    • Be careful not to tear the digitizer cable when threading it through the plastic housing.

  8. Carefully separate display assembly from the plastic housing.
    • Carefully separate display assembly from the plastic housing.

Sonuç

To reassemble your device, follow these instructions in reverse order.

9 farklı kişi bu kılavuzu tamamladı.

Sean Kramer

Üyelik tarihi: 14-02-2018

1.071 İtibar

6 adet Kılavuz yazıldı

Takım

USF Tampa, Team S5-G4, Eyestone Spring 2018 USF Tampa, Team S5-G4, Eyestone Spring 2018 üyesi

USFT-EYESTONE-S18S5G4

3 Üyeler

6 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 Gün: 25

Son 30 Gün: 117

Her zaman: 1,730