Ana içeriğe geç

Giriş

Prereq to remove the interior midframe and motherboard assembly.

  1. Remove the ten 3.4 mm Phillips #000 screws from the display side of the midframe.
    • Remove the ten 3.4 mm Phillips #000 screws from the display side of the midframe.

  2. Flip the phone over and remove the following screws from the battery side of the midframe:
    • Flip the phone over and remove the following screws from the battery side of the midframe:

    • Two 4.4 mm Phillips #000 screws near the USB port on the battery side of the phone

    • One 4.4 mm Phillips #000 screw

  3. Gently run a plastic opening tool down along the left inner side of the interior frame to separate the three white plastic clips. Gently run a plastic opening tool down along the left inner side of the interior frame to separate the three white plastic clips. Gently run a plastic opening tool down along the left inner side of the interior frame to separate the three white plastic clips.
    • Gently run a plastic opening tool down along the left inner side of the interior frame to separate the three white plastic clips.

  4. The midframe is composed of two halves that encase the motherboard. Gently pull the long sides of the silver bezel out away from the phone to separate the two halves of the midframe.
    • The midframe is composed of two halves that encase the motherboard.

    • Gently pull the long sides of the silver bezel out away from the phone to separate the two halves of the midframe.

    • It may be helpful to gently push in from the inside of the battery compartment, but be careful not to flex the interior half of the midframe, as the motherboard is mounted to it.

  5. Continue on to the right side of the silver bezel, pulling away from the interior section of the midframe to separate the two halves. Continue on to the right side of the silver bezel, pulling away from the interior section of the midframe to separate the two halves.
    • Continue on to the right side of the silver bezel, pulling away from the interior section of the midframe to separate the two halves.

  6. Use a plastic opening tool to pry any remaining corners out of the silver bezel. Use a plastic opening tool to pry any remaining corners out of the silver bezel.
    • Use a plastic opening tool to pry any remaining corners out of the silver bezel.

  7. Carefully remove the interior midframe/motherboard assembly from the white inner midframe. Carefully remove the interior midframe/motherboard assembly from the white inner midframe.
    • Carefully remove the interior midframe/motherboard assembly from the white inner midframe.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Sam Goldheart

Üyelik tarihi: 18-10-2012

382.360 İtibar

543 adet Kılavuz yazıldı

Takım

iFixit iFixit üyesi

Community

101 Üyeler

9.066 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 2

Her zaman: 319