Ana içeriğe geç

Samsung Galaxy Watch Active2 Back Cover Replacement

What you need

  1. Samsung Galaxy Watch Active2 Back Cover Replacement, Turn off the watch: adım 1, 2 resimden 1. Samsung Galaxy Watch Active2 Back Cover Replacement, Turn off the watch: adım 1, 2 resimden 2.
    • Turn off the Galaxy Watch Active2 by pushing and holding the bottom button for approximately 3 seconds. You should feel a short vibration.

    • When the "Power off" symbol appears, tap the center of the screen to make it shut down. You should feel a longer vibration for confirmation.

  2. Samsung Galaxy Watch Active2 Back Cover Replacement, Remove the rear screws: adım 2, 1 resimden 1.
    • Use a Tri-point Y00 screwdriver to remove the four 4 mm-long screws on the back of the watch.

  3. Samsung Galaxy Watch Active2 Back Cover Replacement, Separate the back cover from the housing: adım 3, 3 resimden 1. Samsung Galaxy Watch Active2 Back Cover Replacement, Separate the back cover from the housing: adım 3, 3 resimden 2. Samsung Galaxy Watch Active2 Back Cover Replacement, Separate the back cover from the housing: adım 3, 3 resimden 3.
    • Use an opening pick and place it between the plastic back cover and the metal housing near the buttons.

    • Push the opening pick into the gap to separate the back cover from the housing.

    • Don’t remove the back cover all the way yet. There is a cable connecting it to the motherboard.

  4. Samsung Galaxy Watch Active2 Back Cover Replacement, Disconnect the sensor array: adım 4, 2 resimden 1. Samsung Galaxy Watch Active2 Back Cover Replacement, Disconnect the sensor array: adım 4, 2 resimden 2.
    • Carefully lift the back cover to access the sensor array connector.

    • Use a spudger to disconnect the sensor array from the motherboard.

  5. Samsung Galaxy Watch Active2 Back Cover Replacement, Remove the back cover: adım 5, 1 resimden 1.
    • Remove the back cover.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers community for help.

6 farklı kişi bu kılavuzu tamamladı.

Tobias Isakeit

Üyelik tarihi: 03/31/14

107.254 İtibar

185 adet Kılavuz yazıldı

Team

iFixit iFixit üyesi

Community

138 Üyeler

16.925 adet Kılavuz yazıldı

4 Comments

What kind of glue would you use if the plastic of the back cover fell off?

Dave Hains - Yanıt

Hello. Where can i get the back cover with adhesive as a replacement or just the adhesvie? I noticed it is a weird rubbery glue and i cannot source this anywhere.

Arbuzov Paul - Yanıt

What kind of glue would you use if the plastic of the back cover fell off

Ilona Smit - Yanıt

Why would you use glue? The back is fixed with screws.
If there is a loose part on the back cover you might want to try a glue like the E6000, B7000 or T9000 (there are different combinations out there)

Tobias Isakeit -

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 33

Son 7 gün: 166

Son 30 gün: 835

Her zaman: 19,323